对铅碳电池充电接受能力的再认识

来源 :第十八次全国电化学大会 | 被引量 : 0次 | 上传用户：zjfjh2008

【摘要】

：

电化学储能的核心在于开发在深度充放电条件下具有长循环寿命的储能系统.在化学电源中,铅碳电池由于性价比高,是最有希望用于大规模储能系统的化学电源之一[1].铅碳电池是铅酸电池技术的发展,在过去10年中取得了很大进展,尤其在混合动力汽车中的应用研究受到了众多研究者的关注[2].然而,铅碳电池在可再生能源储能方面仍然面临着巨大挑战.

【作者】

：

张文礼林哲琪尹健林海波陆海彦

【机构】

：

吉林大学化学学院,吉林,长春,130012 吉林大学化学学院,吉林,长春,130012;吉林大学(

【出处】

：

第十八次全国电化学大会

【发表日期】

：

2015年7期

下载到本地 , 更方便阅读

下载此文赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

其他文献

Low velocity impact properties of aluminum foam sandwich structurecomposites

Sandwich structure composites were prepared by aluminum foam and basalt fiber, ultra-high molecular weight polyethylene(UHMWPE) fiber composite faceplate.The factors influencing the impact properties

会议

aluminum foamsandwich structurebasalt fibersUHMWPEimpact properties

The effect of substrate position on the microstructure of CVD SiC coating

Silicon carbide coatings were fabricated by chemical vapor deposition method using domestic graphite as substrate and methyltrichlorosilance as precursor.Two frock design: drum type and steamer type,

会议

chemical vapor depositionsilicon carbidemicro-structurecoating

R-curve behavior and thermal shock resistance of SiC-graphite composites prepared by PAS sintering p

SiC-graphite ceramic composites were successfully fabricated by plasma activated sintering (PAS) method at 1680 ℃.The effects of graphite content on the physical mechanical properties, toughness, R-cu

会议

SiC-graphiteCeramic compositesToughnessR-curveThermal shock resistance

Microwave absorption properties of LiZn ferrites hollow microspheres doped with La and Mg by self-re

Lithium-Zinc ferrite hollow microspheres (LiZn FHMs) doped with La, Mg were synthesized by Fe+Zn+Fe2O3+O2+Li2CO3 reactive system based on self-reactive quenching technology.Influence of La, Mg doping

会议

LiZn ferriteMg and La dopinglow frequencymicrowave absorption properties

Optimization of Structure Design Parameters and Mechanical Properties of Mg-Al-Ti Composite Sheets F

The Mg-Al-Ti laminated metal composite sheet combines the advantages of high strength of Ti, light weight, easy melt and atomization of Mg, and good space adaptability of Al.It is well suited to as bu

会议

bonding interfacehot roll bondinglaminated metal composite sheet(LMCS)dissimi

ApplicationsMechanical and thermal properties of reduced graphene oxide reinforced AlNcomposites

High density reduced grapheneoxide (rGO) reinforced aluminum nitride (AlN) composites were successfully fabricated by one-step spark plasma sintering (SPS) method.Raman spectra showed that the raw mat

会议

Reduced graphene oxideAluminum nitrideMechanical propertiesThermal properties

The Preparation and Ablation Propertiesof Three Dimensional Co-continuousSiCp/(Cu-Si) Composites

In this study a porous SiC ceramic reinforced copper-matrix composite was fabricated by mean of pre-sintering of the as-pressed porous SiC preform and spontaneous infiltration of molten Cu-Si alloy in

会议

Porous SiC ceramicsVacuum infiltrationBi-continuous SiC/(Cu-Si) compositeThe

PrestressedSiC ceramic and its effects on the ballistic performanceof metal-ceramic armor investigat

Apply stable prestress in the SiC ceramic in SiC-Ti6AL4V 3D confinement metal-ceramic armor system in numerical simulation.Invesitigate the unprestressed and prestressed SiC-Ti6AL4V armor systems anti

会议

Silicon carbidePrestressoblique effect

形状记忆合金复合材料单轴拔出界面力学特性

形状记忆合金复合材料拥有功能和承载的双重特性，未来在航空航天和轨道交通等领域具有良好的应用前景。针对形状记忆合金纤维单轴拔出行为，本文通过将纤维与基体粘结界面等效为界面相，构造了三相同轴圆柱单纤维拔出模型，并基于应力函数法和最小余能原理求解了三相材料内部应力分布方程，讨论了纤维长细比和模型长度对应力分布的影响，通过断裂力学方法求解了纤维复合材料界面临界脱粘准则，拔出实验结果和数值结果进行了对比。

会议

形状记忆合金复合材料拔出模型界面力学

锂离子动力电池用陶瓷涂覆功能隔膜的设计与研发

在含有电解液的电池体系中,隔膜是置于正、负极材料之间,防止电极物理接触且允许离子自由导通的重要材料[1].一般而言,隔膜材料必须具备良好的电绝缘性,并在较宽的温度和电压范围内能保持化学稳定性.目前,商品化液态锂离子电池中使用的隔膜材料主要是微孔的聚烯烃类薄膜,如聚乙烯(Polyethylene,PE)、聚丙烯(Polypropylene,PP)的单层或多层复合膜.

会议

对铅碳电池充电接受能力的再认识

与本文相关的学术论文