Development of aluminum steering support

来源 :15th International Conference on Aluminium Alloys(ICAA15)(第十 | 被引量 : 0次 | 上传用户：qq774257837

【摘要】

：

【作者】

：

Qin Yang Xianhe Wu Bo Liu Ke Wang Zhongcai Qiu

【机构】

：

Chongqing Changan Automobile Co., Ltd, China Chon

【出处】

：

15th International Conference on Aluminium Alloys(ICAA15)(第十

【发表日期】

：

2016年3期

下载到本地 , 更方便阅读

下载此文赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

The steering support is the important part because it is high demand for safety, vibration and noise reduction, and as the connection and supporting the dashboard, various electrical appliances and installation of the steering column, the parts design is very complex.At present, the main trend is to use steel steering support.The aluminum is selected to make this part for lightweight and safety.At the same time it solve too much steel brackets, the low precision after CO2 welding, the low assembly accuracy with the surrounding parts.

其他文献

Photovoltaic Performance of Solar Grade Silicon by Metallurgical Route with Electro-beam Melting

Electron beam melting (EBM) system has been used to improve the purity of metallurgical grade silicon (MG-Si) feedstock for photovoltaic application.Our advanced EBM system with the combination of vac

会议

Characterization of Si particles and their effects on mechanical properties in a nanostrucutred Al-1

An Al-1.08 vol.％ Si alloy was cold rolled to a reduction of 98％ (εvM =4.5) and then annealed at different temperatures up to 250 ℃ for different times.The morphologies of the Si particles were charact

会议

Comparative and complementary characterization of precipitate microstructures in Al-Mg-Si(-Li) alloy

In this study, comparable and complementary characterization of precipitate microstructures by transmission electron microscopy (TEM), energy dispersive X-ray spectroscopy (EDS) and atom probe tomogra

会议

Microstructure and property evolution of an Al-Mg-Sc-Zr alloy after selective laser melting

It is well known that scandium can significantly improve the microstructure and properties of aluminium alloys, especially in terms of grain structure control and precipitation hardening.However, appl

会议

Variant selection of the S (Al2CuMg) precipitates at dislocations in Al-Cu-Mg alloy

The heterogeneous nucleation of S (Al2CuMg) precipitates at dislocations during artificial ageing is a very common phenomenon in Al-Cu-Mg alloy.Specifically, the nucleation of the S variant or variant

会议

Partial melting, segregation behavior and nanomechanical properties of AlCu2Si1Mg0.6 alloy

The AlCu2Si1Mg0.6 alloy was investigated on a scanning electron microscope with an attachment for electron probe microanalysis (EPMA) and X-ray diffraction analysis (XRD).The measurements of nanohardn

会议

The influence of trace elements (In, Sn) on the hardening process in AlCu-alloys by positron annihil

AlCu-based alloys have important applications as high-strength and lightweight materials for the fuselage in aviation (AlCuMg, AlCuLi) and as cast-alloys (AlSiCu) for engine blocks in the transport se

会议

Heterogeneous nucleation of α-Al grain on primary α-AlFeMnSi intermetallic investigated using 3D SEM

Microstructural examination of the Al-5.3Mg-2.4Si-0.6Mn-1.0Fe alloy in the die-cast condition revealed that a significant number of the primary α-AlFeMnSi intermetallic particles were found inside bot

会议

Mechanisms of void shrinkage in aluminium

Voids in aluminium can significantly affect materials performance and a key question is their evolution.We characterised the shrinkage of voids in quenched pure aluminium by performing in-situ anneali

会议

Effects of Sn addition on clustering and age-hardening behavior in a pre-aged Al-Mg-Si alloy

The effects of Sn addition on clustering and age-hardening behavior in an Al-0.6Mg-1.0Si (mass ％) alloy were investigated.The specimens were solution treated at 843K and quenched followed by pre-aging

会议

Development of aluminum steering support

与本文相关的学术论文