• 不 限
  • 期刊论文
  • 硕博论文
  • 会议论文
  • 报 纸
  • 英文论文
  2. 您的位置
  3. 首页
  4. 会议论文
  5. Analysis of Performance of a Free Piston Stirling Engine

Analysis of Performance of a Free Piston Stirling Engine

来源 :2nd International Workshop on Heat Transfer Advances for Ene | 被引量 : 0次 | 上传用户：eboy120
【摘 要】
：
Free Piston Stirling Engine(FPSE), which was initially designed by W.Beale in the early 1960s, has been widely used in concentrating solar thermal power systems.FPSE is considered to be a very promisi
【作 者】
：
Haiyu Yang Zhen Yang Yuanyuan Duan 
【机 构】
：
Key Laboratory for Thermal Science and Power Engineering of Ministry of Education, Beijing, Key Labo
【出 处】
：
2nd International Workshop on Heat Transfer Advances for Ene
【发表日期】
：
2013年1期
【关键词】
：
Free piston Stirling engine thermodynamic analysis numeric simulation CFD 
下载到本地 , 更方便阅读
下载此文 赞助VIP
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
　　Free Piston Stirling Engine(FPSE), which was initially designed by W.Beale in the early 1960s, has been widely used in concentrating solar thermal power systems.FPSE is considered to be a very promising engine because it is small, efficient and without sealing problems.
其他文献
Numerical model and parameter investigation of transient carbon deposition in Solid Oxide Fuel Cell
Solid oxide fuel cells (SOFCs) allow conversion of a wide range of fuels, including various hydrocarbon fuels.The relatively high operating temperature allows for highly efficient conversion to power,
会议
Solid oxide fuel cellCarbon depositionTransient effectsModelingParameter stu
Dynamic droplet behavior of dropwise condensation heat transfer
The dynamic droplet behaviors, such as coalescence, departure, and out-of-plane jumping, can lead to great effect on the dropwise condensation (DWC) heat transfer.This paper briefly introduces this to
会议
Dropwise condensationHydrophobic and superhydrophobic surfaceDroplet dynamics
Recent Developments In Impingement Array Cooling, Including Consideration of the Separate Effects of
Presented are data which illustrate the effects of Mach number, Reynolds number, temperature ratio, and hole spacing on surface Nusselt numbers produced by an array of jets impinging on a flat plate.T
会议
Impingement array coolingheat transfer augmentationconvective heat transfertu
Multi-objective optimization of electronics heat sink geometries
Fins and fin arrays, which are used to enhance heat transfer, should be small in weight and volume, and the fans, which create flow, should consume little energy.Furthermore, to prevent failure, compo
会议
Fin array Heat sinkMulti-objective optimizationTurbulent flow
Investigation of a total heat exchanger with cross-corrugated triangular ducts
Membrane-based total heat exchanger is a device to recover both sensible heat and moisture from exhaust air stream from a building.Heat and mass transfer intensification was performed by using a struc
会议
Cross-corrugated ductsparallel flat plate ductstotal heat exchangerheat and m
Applications of laser diagnostics to engines and thermal power plants
It has been a major challenge to reduce anthropogenic carbon dioxide emissions in combustors.Behind the trend is the fact that increased carbon dioxide in the air causes global warming and adversely a
会议
Temperature and concentration measurementCT-tunable diode laser absorption spec
Experimental Investigation on the CaCO3 Fouling Characteristics of Titanium Tube
Fouling deposition is critical factors governing the performance of heat exchanger.In present study, fouling characteristics of titanium tube were evaluated by comparing experiment accounting for flow
会议
Fouling characteristicsTitanium tubeComparing experiment
Experimental Investigation of Nanoparticle Dispersions for Solar Thermal Applications
Solar thermal systems (STS) are widely used to harness solar energy for thermal energy (heat) applications.Depending on the applications, solar thermal collectors are classified as low-, medium-or hig
会议
A Feasibility Study on Retrofitting CHP (Combined Heat and Power) Engines in a District Heating Syst
As a part of expansion plan of an existing district heating system, CHP (combine heat and Power) engine installation is studied.Load models are developed by statistically processing the most recent th
会议
Combined Heat and Power (CHP)District heatingEconomic assessment.Operation sim
Numerical Study on Heat transfer Enhancement of Circular Tube Bank Fin Heat Exchanger with Interrupt
A variation in fin surface geometry is an effective approach to improve streamline pattern when fluid flows through the channel form by circular tube bank fin.The structure of interrupted half annular
会议
Heat transfer enhancementInterrupted annular groove finTube bank fin heat exch