【摘 要】
：
This work is an experimental study on solid solution strengthening of aluminium alloys.Flow behaviour of high-purity Al-Mg and Al-Si binary alloys is characterised and compared to that of a base mater
【机 构】
：
University of Rostock, Faculty of Mechanical Engineering and Marine Technology, Materials Science, G
【出 处】
：
15th International Conference on Aluminium Alloys(ICAA15)(第十
论文部分内容阅读
This work is an experimental study on solid solution strengthening of aluminium alloys.Flow behaviour of high-purity Al-Mg and Al-Si binary alloys is characterised and compared to that of a base material (99.99％ pure Al).Uniaxial compression tests have been carried out in a quenching and deformation dilatometer allowing precise heat treatments prior to mechanical testing.Samples were solution treated and quenched to various temperatures coveting the range from room temperature up to 500℃.
其他文献
本文通过对多联式空调系统原理和会所类建筑相关特点的论述,阐述了会所类建筑使用多联式空调系统的优势,为多联式空调在会所建筑中的推广使用提供了一定的理论依据.多联机VRV空调系统是为适应空调机组集中化使用需求在分体式和多联式空调系统基础上发展起来的一种新型制冷剂空调系统。其主导思想是“变频、一拖多和多拖多”，体现变频空调的节能理念。会所式建筑作为一种高档且规模不大的住宅式建筑，往往位于市政设施相对不够
The effect of heat treatments, which include interrupted-quenching, pre-aging and restoration, on microstructure and mechanical properties of 6016 aluminum alloy were investigated with hardness test,
根据酒店项目的地域特点、建筑功能及业主提出的要求,对滕州某酒店项目空调冷、热源系统采用常规电动压缩式制冷、溴化锂吸收式制冷(供热)、市政热水供热及燃气热水锅炉供热的可行性进行分析与比较,并提出合理的方案论证及建议.
Strengthening aluminum alloys is a longstanding task since the discovery of the age-hardening phenomenon in 1906.The upper strength limit of bulk Al alloys is ～0.7 GPa by conventional precipitation st
The effects of microstructural characteristics on the fretting fatigue behavior in Al-Zn-Mg alloy were systematically investigated.The dislocation substructures of Al-Zn-Mg alloy under different stres
A new technology for materials development,Reverse 4D Materials Engineering(hereinafter R4ME), is achieved through the utilization of 3D/4D imaging technique and image-based simulation.R4ME is a rever
For weldable structures of aerospace application non-heat treatable Al-Mg alloys are widely used.Improvement of mechanical properties of these alloys is possible with an additive of small amount of sc
Aluminum alloy drill pipe has been widely used as the effective tools to solve drilling problem for oil and gas Industry due to its high-strength and low density.The materials selection and mechanical
In electrical power systems pre-stressed screw connections of conducting paths/bus-bars out of Al alloys are common, whereby the operating temperature shall be increased up to 140 ℃ in the future.At t
Low temperature creep behavior around room temperature was examined for coarse-grained (CG) and ultrafine-grained (UFG) aluminum.The materials were fabricated through accumulative roll bonding and sub