【摘 要】
：
Al2O3-13wt%TiO2 coatings, formed by means of laser cladding on nickel-based alloy, were heated using high frequency induction sources.The coating and the interface between bond coating and ceramic coa
【出 处】
：
2012 Postdoctoral Symposium of China on Materials Science &
论文部分内容阅读
Al2O3-13wt%TiO2 coatings, formed by means of laser cladding on nickel-based alloy, were heated using high frequency induction sources.The coating and the interface between bond coating and ceramic coating were characterized by SEM, XRD, and EDS.It was found that two layers formed of substructure existed in the ceramic coating: one evolving from fully melted region, another resembling the liquid-phase-sintered structure consisting of three-dimensional net.The XRD and EDS analysis revealed that melted Al2O3 particles were embedded in the TiO2-rich matrix.The mechanism of the substructure formation was also explained in terms of the melting and flattening behavior of the powders during laser cladding processing.Meanwhile, the spinel compounds NiAl2O4 and acicular compounds Cr2O3 have been discovered in the interface between bond coating and ceramic coating, it proved that the laser cladding process by the chemical reactions, will lead to significantly enhance the coating adhesion.
其他文献
Vickers indentation test is used to evaluate the generation and growth of cracks in sintered ores containing different forms of calcium ferrites, and examine the effects of different forms of calcium
The uniform sub-micron colloidal spheres were arrayed on the surface of a Si substrate via self-assembly to forming a sphere-layer film (monolayer), with emphasis on the application of rolling frictio
The ultra-microduplex structure was fabricated in the high carbon steel with a fully pearlitic structure after severe plastic deformation.The microstructures, before and after the deformation, were ob
A modified Swift type flow stress-strain relation is presented in order to describe the uniaxial tension test curve reasonably.The FLD-strain (forming limit diagram made up of limit strain) of 5754O a
Effects of cooling conditions on the microstructure of semisolid AZ91 slurry produced via ultrasonic vibration process were investigated.AZ91 melts were subjected to ultrasonic vibration in different
Dynamic mold temperature injection technology can be used to eliminate many surface defects such as weldline, flow mark that usually appear on the polymer parts.In this paper, fiber reinforced ABS mat
Dielectric properties and varistor performance of sol-gel prepared Ni-doped calcium copper titanate ceramics (CCNTO) were investigated.The XRD patterns showed that the CaCu3NixTi4O12+x (CCNTO) (x =0,
(Ba0.7, Sr0.3)Nb2O6-(1-y)(Ba0.7, Sr0.3)TiO3 (SBN/BST in short) composite ceramics with different Nb/Ti ratios were fabricated using a Powder-Sol (P-S) method with Nb2O5 fine powders suspended in the b
The (Mol-xNbx)Si2 (0≤x≤0.5) was successfully prepared using the combustion synthesis method by Mo, Nb, and Si elemental powders.The influences of niobium on the combustion mode, combustion temperature
To further enhance shape memory effect (SME) and improve treatment technique in Fe-based shape memory alloys, an Fel7Mn5Si8Cr5Ni0.5NbC alloy was subjected to electropulsing treatment after pre-deforma