【摘 要】
：
Right evaluation of the bond behavior between corroded reinforcing bar and concrete wrapped with fiber reinforced polymers (FRPs) is a chief problem to confirm the effect of FRP confinement.the pullou
【出 处】
：
2012 Postdoctoral Symposium of China on Materials Science &
论文部分内容阅读
Right evaluation of the bond behavior between corroded reinforcing bar and concrete wrapped with fiber reinforced polymers (FRPs) is a chief problem to confirm the effect of FRP confinement.the pullout tests on 96 test specimens were conducted to study the effect of Carbon FRP (CFRP) confinement on the bond behavior between corroded reinforcing bar and concrete, test variables included reinforcing bar types, concrete covers, degrees of corrosion and CFRP confinements.The test results show that CFRP confinements can make the failure mode of deformed reinforcing bar specimens change from concrete splitting to bar pullout.When the degree of corrosion is less than 5%, the ultimate bond strength of corroded specimens increases by 5%~7%, and the CFRP confinement has less contribution on the ultimate bond strength, but it is effective on slowing down the bond stress descending speed and maintaining the bond strength.When the degree of corrosion is higher than 5%, the ultimate bond strength of corroded specimens drops gradually with the increase of degree of corrosion.
其他文献
Cu-SAPO-34/cordierite catalysts were prepared via one-step hydrothermal synthesis procedure and their performances to remove NOx from the diesel vehicle exhaust were evaluated.Its morphology, structur
In order to enhance the surface properties of P 110 oil casing tube steel and increase its life-time during operation, chromizing coating was fabricated by pack cementation.Scanning electron microscop
Bronze-impregnated carbon-matrix composites were prepared through compression molding, carbonization and impregnation.The mechanism of sulfuration was studied and the effect of coal tar pitch modified
The change process of MnS inclusions in heavy rail casting slab was in-situ observed by confocal laser scanning microscope.The result shows the MnS has shape evolution owing to the influence of the di
The effect of activator and its dosage on the early hydration and setting performances of alkali-activated slag cement (AASC) is very important.The effects of activator type, modulus of water glass (M
The Hoek-Brown (HB) strength criterion has been widely applied to the estimation of strength of intact rock and rock mass, whose yield function includes general form (a ≠ 0.5)and special form(a=0.5).I
This paper presented quantitatively the results of an experimental investigation on the influence of either mineral admixtures, fly ash or GGBS and superplasticizers on micro hardness of aggregate to
The magnetic hysteresis loop is a significant performance of ferromagnetic material.The different-size specimens were fabricated and studied on the basis of magnetomechanical coupling tests.The curve
The effect of annealing temperature in the range of 1020℃-1120℃on the microstructure, mechanical properties and corrosion resistance of low-Nickel duplex stainless steel was investigated.The results s
The microstructures of Mg-2Nd-4Zn-lZr alloy in the as-cast and after heat treatment were investigated.Several kinds of secondary phases were found and characterized by transmission electron microscopy