Thermodynamic Analysis in Sintering Reaction of Coal Fly Ash with Alkali

来源 :2014中国功能材料科技与产业高层论坛 | 被引量 : 0次 | 上传用户:pearljeejee
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
  With sodium carbonate and calcium oxide as sintering additives, through the thermodynamic analysis and sintering experiment, study the thermodynamic behavior of fly ash with both in the sintering process;the sintering products were analyzed by XRD.
其他文献
Mg-doped GaN nanowires have been successfully synthesized on Si (111) substrates by magnetron sputtering deposition through ammoniating Ga2O3/Au thin films at 900 ℃ for 15 min.
In this study, hollow glass microspheres (HGM) and hollow polystyrene microspheres (HPSM) have been employed as fillers in epoxy resin to prepare the syntactic foam.A kind of good performance composit
In order to prevent Zn2SiO4:Mn2+with short decay time for 3D plasma display panels (PDPs) from the deterioration of the luminescence efficiency caused by vacuum ultraviolet (VUV) irradiation, MgF2 coa
Self-assembled method for controllable fabrication of a hydrophobic triazine dithiol-silane composite film on 304 stainless steel (SS) is reported in this paper.Hierarchical structure composed of micr
One lanthanide nitrate (Ln =Tb)with a novel three dimensional structure have been prepared through hydrothermal method.Singlecrystal X-ray diffraction structures were obtained.
A monetite coating was deposited on Carbon/Carbon composites(C/C) by a chemical liquid vaporization deposition (CLVD) method, and then hydrothermally conversed to a hydroxyapatite (HA) coating.
本文探讨了无水压裂用烷基磷酸酯凝胶剂的合成条件,确定了最佳酯化温度为85~90℃.反应时间为5h,并用多元醇与聚磷酸酯中间体反应合了成常温下为液态的烷基磷酸酯凝胶剂JED-3S.
The microenvironment has been shown to regulate cellular functions including cell growth, differentiation, proliferation, migration, cancer development and metastasis.
以Sm(NO3)3· 6H2O溶液和NaVO3为原料,使用微波水热法,通过对前驱液pH进行控制,制备了四方相SmVO4纳米粉体。利用X射线衍射仪、扫描电子显微镜、透射电子显微镜以及紫外可见漫反射光谱分别对产物的物相组成、微观形貌和光学性能进行表征,并研究了不同前驱液pH值对产物的物相组成、微观形貌和光学性能的影响。
基于碳布优异的耐热性能、摩擦磨损性能和纳米MoS2的自润滑特性,采用纳米MoS2改性处理碳布摩擦材料以适用于高载荷、高转速或润滑不充分等特殊的工况条件。本文通过在树脂浸渍液中加入不同质量分数的纳米MoS2对摩擦材料进行改性处理。