【摘 要】
：
The effect of softwood based calcium-and sodium lignosulfonates on the early hydration of pastes of cubic and orthorhombic C3A with gypsum was investigated using isothermal calorimetry, XRD analysis a
【机 构】
：
Department of Materials Science and Engineering, NTNU-Norwegian University of Science and Technology
【出 处】
：
The 14th International Congress on the Chemistry of Cement (
论文部分内容阅读
The effect of softwood based calcium-and sodium lignosulfonates on the early hydration of pastes of cubic and orthorhombic C3A with gypsum was investigated using isothermal calorimetry, XRD analysis and thermogravimetry.For XRD paste hydration was stopped with liquid nitrogen and isopropanol after 5, 15, 30 min and 1, 2, 5 h.Additional experiments were performed on Portland cement (PC) pastes for comparison.Calcium lignosulfonate increased the initial heat of hydration in C3A-gypsum pastes while the second hydration peak was retarded and reduced.With sodium lignosulfonate the first heat peak appeared after about 0.7 h.In the PC system no difference in retardation effect was detected between the two lignosulfonates.XRD analysis and thermogravimetry could not detect the difference in performance between calcium and sodium lignosulfonate as observed with calorimetry.It was found that the complete gypsum consumption in pastes was retarded with both lignosulfonates, whereas the early ettringite formation in pastes of C3A and PC seems to be accelerated.Both lignosulfonates appear to stabilize AFm phases, which are not observed in pastes without LS.There are indications of a possible change in the morphology of ettringite.
其他文献
Nanosilica (nSiO2) as a cement-based composites additive, exhibits tremendous properties which can positively affect a variety of concrete and cement mortar properties such as: compressive, flexural a
The usage of superplasticizers for concrete production is beneficial in terms of workability and water reduction.Therefore, superplasticizers enable the production of concretes with increased flowabil
Cement slurries have been designed to remain liquid for extended periods of time (>weeks) until exposed to neutron or ionizing radiation to provide a triggered activation mechanism.The cement setting
Polycarboxylate ether/ester (PCE) superplasticizer has gotten wide spread application in ready mixed concrete so far.But the use of PCE in pre-stressed high strength concrete tubular pile (PHSCTP) has
This study attempts to estimate the relation between the adsorption of the molecules on calcium silicate hydrates (C-S-H) and their ions complexation on their retarding effect on tricalcium silicate h
The sorption behavior of two lignosulfonates onto two different cements was investigated via GPC and ultraviolet spectroscopy.Rapid sorption occurred and more than 80% of the added lignosulfonate were
The influences of aggregate micro fines (AMF) on the strength, early shrinkage and pore structure of mortar,which is mixed with limestone manufactured fine sand (MFA) at a water-to-cement ratio of 0.5
The present study investigates the compressive strength, water absorption, electrical resistivity, and chloride permeability of self-compacting mortar (SCM) specimens containing fly ash and nano-TiO2
Retarders are typically used in concrete mixtures to control the time of set, allowing for extended placement times and transport.High dosages of retarder can cause cement systems to take days or long
The adsorption amount of polynaphthalene sulphonate superplasticizer (NSF) on the surface of alite-sulphoaluminate cements of different mineral composition were detected by ultraviolet-visible absorpt