【摘 要】
：
For high-voltage transmission project, the security of energy consumption in the transmission lines is of particular importance.The stability and security of the high-voltage transmission system is de
【机 构】
：
School of Power and Mechanical Engineering of Wuhan University, Wuhan, China 430072
【出 处】
：
2015 International Workshop of Wireless Power Transfer(2015无
论文部分内容阅读
For high-voltage transmission project, the security of energy consumption in the transmission lines is of particular importance.The stability and security of the high-voltage transmission system is determined by the reliability and operation of transmission lines.Abnormal energy consumption will result in considerable economic losses and energy waste, especially in the transmission of bulk power system.So there are several on-line monitoring technologies applied to the high-voltage transmission lines, such as insulator contamination,thunderstorm and environmental monitoring.In addition,the on-line detection techniques including inflated detection, ultraviolet detection and ultrasonic testing are utilized to find and remove hidden troubles.However,there is a great probability of being affected by weather variations, poor reliability and stability in these facilities equipped with solar-cell panels or wind power in the inaccessible areas.
其他文献
以二甲苯和正丁醇的混合溶液为分散介质,B4C粉体为分散相,探究B4C在该溶液中的分散机理。实验结果表明：不同质量比的混合溶液对B4C粉体的分散效果不同,分散效果随溶液中正丁醇质量分数的增大呈先增强后减弱的趋势,在质量比为7∶3的二甲苯和正丁醇溶液中分散效果最好。通过FT-IR、XRD、TEM、Zeta电位、pH值测试,确定分散机理为：受苯环结构的影响,富硼结构的B4C与正丁醇反应,形成化学键合,产
采用溶剂热法制备染敏化太阳能电池用TiO2散射层颗粒，考虑溶剂选择对TiO2微米颗粒尺寸分布影响.实验测试结果表明：在其它条件相同的前提下，溶剂的粘度对晶体成核与生长这两个过程有很大的影响，高粘度溶剂易于晶粒成核，但不利于后期过程中的传质生长.因此，所得尺寸排序为D50-乙醇＞D50-乙二醇＞D50-丙三醇.将三种样品分别应用于染料敏化太阳能电池中散射层均可提高其光电转换效率，其中以丙三醇中合成出
钙钛矿型氧化物La0.6Sr0.4Co0.2Fe0.8O3-δ(LSCF)是目前最理想的中温SOFC的阴极材料之一.寻找合适的合成方法以同时满足LSCF纳米粉体的高性能和大规模制备,并制备出性能出色的LSCF阴极粉体,对推动中温SOFC的发展具有重要意义.通过比较固相法和喷雾裂解两种方法制作出的固体氧化物燃料电池阴极粉体LSCF的电池性能.结果表明：喷雾裂解该方法合成产物为钙钛矿结构La0.7Sr
铝酸盐蓝、绿粉荧光粉具有化学性质稳定的,既不溶于酸,也不溶于碱,是目前稀土回收率低的主要原因.为高效回收蓝、绿粉中Tb、Eu和Ce元素,本文研究了蓝、绿粉碱熔分解过程中的晶型转变和稀土离子迁出过程.阐明了蓝、绿粉碱熔崩塌机理：首先Na+取代镜面层中的稀土和碱土离子,由于价态的不同,产生间隙Na+或氧空位,导致晶体结构失稳,晶格从镜面层开始崩塌.反应继续到尖晶石层,Na+置换尖晶石层Mg2+,晶格重
以酸性硅溶胶为原料,采用燃烧合成法快速制备了蓝色长余辉发光材料Sr2MgSi2O7∶Eu2+0.02,Dy3+0.02粉体.通过X射线粉末衍射(XRD)、扫描电镜(SEM)和荧光分光光度计等对其进行微结构、表面形态和发光性能研究,同时探讨了硅溶胶、尿素以及温度等各种工艺条件对最终产品性能的影响.结果表明：Sr2MgSi2O7∶Eu2+0.02,Dy3+0.02晶体为简单四方结构,激发带峰值位于35
Anodising industries produces large quantity of waste acid solutions containing high amounts of SO42-and Al ions.The work reported here is to synthesize high purity α-Al2O3 particles from waste anodic
以竹炭和紫砂土为主要原料,通过不同成珠法制备了竹炭紫砂毫/微珠空气净化器.经108℃真空烧结后,紫砂与竹炭结合良好.采用BET和SEM分析,可见竹炭孔隙结构完整保留,孔径大致在1-5 nm,比表面积Sg=1078.5 m2/g.以NH3、H2S和CH2O为目标物,考察样品吸附性能,样品对它们净化率分别为92.6％、94.3％、87.7％.
对应用于陶瓷窑炉烟气余热回收用气-气热管换热器进行数值模拟。模拟了热管换热器烟气侧和空气侧气体的流动和传热特性。得到了烟气侧和空气侧的速度、压力和温度分布。研究发现烟气侧和空气侧的压力最高区域均出现在热管管壁与迎面气流接触处，压力最低的区域出现在热管壁面的后部区域。空气侧最高温度区域是热管壁面，最低温度出现在管壁之间的中心区域，而烟气侧正好相反。
The rapid and widespread diffusion of digital printers is turning inkjet printing into the leading technology in ceramic tile decoration.The purpose of this overview is to outline the evolution of ink
I INTRODUCTION In order to achieve the highest efficiency of wireless power transfer (WPT) systems, the quality factor of the resonant coil should be as high as possible.Due to the skin-effect and the