2. 您的位置
3. 首页
4. 会议论文
5. Thermoelastic fracture analysis of functionally graded materials with the numerical manifold method

Thermoelastic fracture analysis of functionally graded materials with the numerical manifold method

来源 :中国计算力学大会2018暨国际华人计算力学大会2018 | 被引量 : 0次 | 上传用户：namedmat123

【摘 要】

：

Due to its dual cover systems,i.e.,the mathematical cover and the physical cover,the numerical manifold method(NMM)is superior in crack modeling.In this work,the NMM is further developed to study the

【作 者】

：

Huihua Zhang Simin Liu Shangyu Han 

【机 构】

：

School of Civil Engineering and Architecture,Nanchang Hangkong University,Nanchang,Jiangxi

【出 处】

：

中国计算力学大会2018暨国际华人计算力学大会2018

【发表日期】

：

2018年10期

【关键词】

：

Functionally graded materials Thermoelastic fracture Numerical manifold method T 

下载到本地 , 更方便阅读

下载此文 赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

　　Due to its dual cover systems,i.e.,the mathematical cover and the physical cover,the numerical manifold method(NMM)is superior in crack modeling.In this work,the NMM is further developed to study the thermoelastic fracture behavior of two-dimensional functionally graded materials.

其他文献

Numerical simulation of crack propagationand branching in rock materials using peridynamic modeling

In this study,a peridynamics(PD)model for the dynamic fracture analysis of shale material has been proposed.As well-known,crack propagation,aggregation,and bifurcation play akey role in the fracture b

会议

Peridynamicsrock materialsDynamic fractureCrack propagationDynamic loads

Singularity eigen-analysis for single material and bi-material propagating V-notches

By introducing the displacement asymptotic expansion around the vertex of a propagating V-notch into elasticity governing equation,radial boundary condition and interfacial continuity condition,the si

会议

propagating V-notchbi-materialsingularity analysisasymptotic expansion method

Durability Analysis of Simulated Dynamic Fracture of ECCs Based on peridynamics at Chloride Diffusio

This study introduced the Peridynamic(PD)model based on the bondbased of ECCs,It was used to simulate the dynamic brittle fracture of ECCs under chloride diffusion to complete the durability analysis.

会议

SIF analysis of multi-crack problems by FEM-SFBEM coupling method

The computational efficiency for analyzing the behaviour of multi-crack structures is still a challenging issue in fracture mechanics.The stiffness matrix of a super cracked element is first formulate

会议

Erdogan's solutionsspline fictitious boundary element methodfinite elemen

基于权函数修正的无网格断裂分析

裂纹附近非连续场和裂尖奇异场是无网格断裂分析中需要处理的两个基本问题。前者多需引入不连续性准则如可视性准则、衍射法和透射法等；后者常采用基函数扩展或试函数增强。然而，上述两个问题均能通过对权函数的修正来进行处理。

会议

断裂裂尖奇异场不连续性准则修正权函数扩展权函数无网格方法

A Study on Numerical Simulation of Slant Ductile Fracture

Ductile fracture is one of the most prevalent failure modes,often found in structural components under extreme conditions.Such failure is considered as the consequence of progressive damage accumulati

会议

Ductile fractureFailure mechanismSlant fractureLode parameterNumerical simul

P-version Finite Element Method and Contour Integral Method for Stress Intensity Factors of Mixed Mo

In this paper,Stress intensity factors of mixed mode crack was investigated by using the p-version finite element method and contour integral method(CIM).The finite element commercial software StressC

会议

Fracturep-version finite element methodContour integral method (CIM)Stress in

FEM Sub-Partition and Substructure Method for Simulating Crack Extension in Elastoplastic Material

A new XFEM approach that combines methods of sub-partition and substructure has been developed to simulate crack extension in elastoplastic material.In the present method FE mesh is independent to cra

会议

Sub-partitionSubstructureElastoplastic fracture simulation

Confinement-Shear Effect of Quasi-Brittle Materials in Tension

In this paper,the Generalized Beam(GB)lattice model is adopted to study the confinement-shear effect of quasi-brittle materials in tensile test.The microstructure of quasi-brittle materials is describ

会议

Quasi-materialConfinement-ShearLatticesMicrostructure

A scaled boundary element method for modelling crack propagation with frictional contact

In the case of arbitrary traction on the side faces of an object,a polynomial function of the radial coordinate can be employed to describe the side-face loads using the scaled boundary finite element

会议

SBFEM (Scaled Boundary Finite Element Method)shape functionscrack propagation