【摘 要】
：
A novel method for producing nanoparticles by flame synthesis using a flash-boiling spray is proposed.In detail,a mixed solution(consisting of precursor and
【机 构】
：
DepartmentofMechanicalSystemEngineering,ToyamaPrefecturalUniversity,JapanDepartmentofMechanicalEngin
【出 处】
：
13th International Conference on Liquid Atomization and Spra
论文部分内容阅读
A novel method for producing nanoparticles by flame synthesis using a flash-boiling spray is proposed.In detail,a mixed solution(consisting of precursor and low-boiling-point solvent)is injected through an injector into an ambient at lower pressure.The injected solution is evaporated rapidly by flash-boiling and forms a homogeneous vapour.Nanoparticles are then generated from the vapour by combustion at high flame temperature.The growth process of TiO2 nanoparticles associated with the proposed method was experimentally investigated.In this experiment,a mixed solution of titanium tetraisopropoxide(TTIP)and cyclohexane was used as the precursor solution for generating nanoparticles.The flow rate of nitrogen carrier gas was changed to investigate the influence of flame-residence time of the TiO2 nanoparticles on the characteristics of the nanoparticles.Moreover,to investigate the sintering process of the TiO2 nanoparticles,the distance from the burner at which the nanoparticles were trapped and collected("nanoparticle trapping distance," hereafter)was changed.The properties of the nanoparticles,namely,particle shape,chemical composition,and distribution of particle diameter,were investigated by scanning electron microscope,X-ray diffraction,and particle-distribution analyser.The results of these investigations show that as nitrogen-carrier-gas flow rate increases,particle diameter decreases(because of short particle flame-residence time)and that the diameter of the nanoparticles is increased by decreasing the nanoparticle trapping distance.
其他文献
The efficiency of irrigation systems and the efficacy of pesticide spraying are key features that must be improved in order to both reduce water consumption
Non-evaporating sprays are simulated using a RANS-based Eulerian model called Ω-Y model,and compared with experimental measurements.The Ω-Y model is imple
In this paper a novel optical high-speed Real-Time Process Monitoring System is proposed and used to measure spray and atomization processes.It captures ima
The entire process of atomization of the fuel in an internal combustion engine plays a very important role in determining the overall efficiency of these en
This paper introduces the newly developed PIV/LIF-PIV diagnostic methods which are capable of simultaneously measuring the flow fields of fuel droplet/vapor
Based on the well-known method of undetermined coefficients,we have developed a new software package called InCLiM for automatic and interactive computation of
The simulation of the liquid-and gas-phase properties of aerated-liquid jets in various quiescent and cross flow conditions are presented in this paper.For
The drying of bi-component droplets may be divided into five stages,including initial droplet heating and evaporation(stage Ⅰ),quasi-equilibrium evaporatio
Three dimensional Computational Fluid Dynamics(CFD)simulations of Gasoline Direct Injection(GDI)combustion in a spray-guided Spark Ignition(SI)engine have b
With a dense mist of fine ink droplets(typically about 50 nL/cc)generated from an effective liquid atomizer,the Aerosol Jet(R)direct-write system can delive