Research on Efficiency of Frequency Transition of High Power Laser and KDP Crystal Clamping Method

来源 :LIMIS 2016——The 4th International Symposium on Laser Interac | 被引量 : 0次 | 上传用户:lpc123456
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
  When we do our jobs in high power laser drivers,we need to transit the foundamental laser with the wavelength of 1053 nm to 2ω or 3ω laser with shorter wavelength.
其他文献
The polymer to ceramic transformation process enabled significant technological breakthroughs in ceramic science and technology,This process offers the means for the design of ceramic microstructures
Highly oriented pyrolytic graphite (HOPG) is ablated by ultrashort laser pulses with different pulse durations (50 fs and 4 ps) and laser fluences (68 J/cm2 and 34 J/cm2) in vacuum (4× 10-4 Pa).
Polyurethane-based black coating is a kind of gloss and flat paint used for stray light shielding in optical imaging systems.It has been reported that the deposition of heat generated by laser changes
In this research,we collected typical some UV fused silica materials,and built outer focusing method with high energy to test bulk damage thresholds of all the samples.
To investigate the influence of initial temperature on the laser ablation impulse coupling coefficient,an experimental setup was established with micro impulse responsibility of μNs level.
Optical components in large aperture optical imaging system and high power laser optics are susceptive to intense laser radiation.
Recently,lasers using planar waveguides as gain media have attracted much attention.The planar waveguide structure is characterized by the doped layer with relatively high refractive index surrounded
Photosensitizer[6,6]-Phenyl-C61-butyric acid isopropyl ester (PCBIP) was synthesized.And its structure was confirmed by UV-vis absorption (UV-vis) spectrum,Fourier transform infrared (FT-IR) spectrum,
Optical thin films are widely applied in the areas of optics and electro-optics.Refractive index is an important factor that determines the optical properties of the films.
Short wavelength,uniform and controllable target illumination is the key requirement for high energy density physics research using laser beams.