【摘 要】
：
Electrical contacts are widely used for telecommunication and electric power as a device directly making and breaking electric current.In the future, those will be more in dispensable.The aim of this
【机 构】
：
Key Laboratory for Nonferrous Metal Materials of the Ministry of Education,Central South University,
【出 处】
：
第十三届国际机电装置会议(IS-EMD2013)
论文部分内容阅读
Electrical contacts are widely used for telecommunication and electric power as a device directly making and breaking electric current.In the future, those will be more in dispensable.The aim of this paper is to reveal the effect of fabrication method on arcing erosion of AgSnO2 contact materials.The experiment was performed under the same conditions.The load currents were set at DC 19V 20A and current-carrying time was about 0.3 second.In this paper, we investigate the characteristics of arc energy, arc time, welding force, mass change, surface morphology and surface profile.Moreover, the effect of fabrication method on the erosion model and the calculation of volumetric erosion were discussed.As a result, the erosion of AgSnO2 fabricated by ASE and MSE method is belong to the erosion model with many small pits.However, the erosion of AgSnO2 fabricated by CSE method is belongs to the erosion model with molten metal pool.Furthermore, the mass change measured by volumetric method is larger than that of weighing method and volumetric method is very important and useful to fully describe the condition of the contact surface.
其他文献
This paper is aimed to find an efficient simulation method to accurately simulate pre-arcing characteristics of quartz sand suse.The research can reveal the factors influencing the pre-arcing characte
Composite natural rubber foams prepared from vulcanization the natural rubber in sulfur curing system with sodium bicarbonate (NaHCO3) as foaming agent added 0, 20, 30, 40, and 50 phr of kaolinite (Al
The main goal of this study is to clarify the arc-characteristics with different surface and shape conditions and to acquire basic insights for designing way for appropriate electrode structure for ar
Both gas pressure buildup and post-arc current are vital factors to estimate the arc-quenching property of a circuit breaker.With a 126 kV puffer-type circuit breaker model designed and produced, expe
Break ares are generated in a DC100V-450V and 10A resistive circuit.Motion of arc spots on the anode and cathode surfaces is observed using a high-speed camera.The supply voltage and contact opening s
Negative group delay characteristics can be used to improve signal-integrity performance such as equalizer for compensation of the group delay of transmission line (TL).This paper newly proposed the e
A growth process of damage shapes (specifically growth of a crater) on a cathode surface of a Ag contact pair and a AgSnO2 contact pair due to break arc discharges was observed and numerically evaluat
To study the molten bridge phenomenon of contacts at the initial breaking process, an experimental device of molten bridge between slowly opening contacts was developed.The system consists of the cont
The time variation of contact resistance of silver contacts is measured.The contacts are contacted at constant contact load, and then the time variation of the resistance is measured for 600 minutes.T
The relationship between contact force and contact resistance during loading and unloading process were measured explicitly using AgPd alloy, stainless steel and sapphire substrate material with Au co