Tri-COMPONENT INTERFEROMETER USING a single laser probe for non destructiVE evaluation

来源 :2016远东无损检测新技术论坛 | 被引量 : 0次 | 上传用户:lijichen
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
  New laser interferometric schemes were recently developed in order to measure three components of the ultrasonic field.The TEMPO 3D is a tri-component,two-wave mixing interferometer capable of simultaneously measuring the out-of-plane component as well as the two orthogonal in-plane components of the surface displacement,using a single laser probe.All wave types can be detected.In this paper,we describe this new technology,which constitutes an advance in ultrasonic field visualization.
其他文献
基于有限元模拟研究了碳纤维增强树脂基层板的相控阵超声聚焦法则设计。通过计算瞬态声场比较了[0]40和[45/90/-45/0] 10两种不同铺层方式下的聚焦行为。结果表明:当使用2890 m/s的恒定声速计算聚焦法则时,实际焦点的位置较预设位置提前,且[0]40层板的聚焦深度较[45/90/-45/0]10层板的小。为实现聚焦法则设计,通过有限元模拟获取了各阵元的延迟时间,使聚焦得到了明显改善,且
学位
粗晶结构引起的低信噪比给铸造奥氏体不锈钢(cast austenitic stainless steel,CASS)的超声无损检测带来了巨大困难.基于电子背散射衍射(electron backscattered diffraction,EBSD)建立的模型模拟CASS的相控阵超声成像过程.为增强信噪比,利用相位相干成像算法(phase coherence imaging,PCI)对全聚焦(tota
学位
学位
运载火箭贮箱铝合金焊缝补焊后需要采用被列入航天科技集团公司限制使用的着色渗透方法检测表面缺陷.本文分析了铝合金熔焊缝的特点,研究了铝合金熔焊缝不同区域对电导率的影响和焊缝表面形状对涡流检测信号的影响.检测结果表明,采用阵列涡流检测方法可以检测出3.0mm×0.2mm×0.3mm的人工槽缺陷.
The previous studies of real-time imaging process use direct delay calculation design on FPGA,because the restricting number of memory on chip.In this paper,to achieve higher frequency,a look-up table
学位
Simulation tools gathered in the CIVA platform dedicated to the modeling of NDT techniques are now extensively used in different industrial sectors.
会议
In order to study the influence of notch characteristics on magnetic memory signals,measured the normal component of magnetic flux leakage Hp(y) of different notch specimens and the relationship betwe