2. 您的位置
3. 首页
4. 会议论文
5. Convective heat transfer of high temperature molten salt in a vertical annular duct with cooled wall

Convective heat transfer of high temperature molten salt in a vertical annular duct with cooled wall

来源 :2nd International Workshop on Heat Transfer Advances for Ene | 被引量 : 0次 | 上传用户：cpts

【摘 要】

：

Convective heat transfer performances of high temperature molten salt in a vertical annular duct with cooled wall were experimentally investigated within the range of Reynolds number 2500-16000, Prand

【作 者】

：

Jianfeng Lu Shiquan He Jing Ding Jianping Yang Junmin Liang 

【机 构】

：

School of Engineering, Sun Yat-Sen University, Guangzhou, 510006, China

【出 处】

：

2nd International Workshop on Heat Transfer Advances for Ene

【发表日期】

：

2013年1期

【关键词】

：

Convective heat transfer Molten salt Annular duct High temperature Heat transfer 

下载到本地 , 更方便阅读

下载此文 赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

　　Convective heat transfer performances of high temperature molten salt in a vertical annular duct with cooled wall were experimentally investigated within the range of Reynolds number 2500-16000, Prandtl number 6.2-9.6, and fluid temperature 300-400oC, respectively.

其他文献

Numerical Investigation of Confined Single Jet Impinging on Dimpled target Surface using Al2O3-Water

Jet impingement has been investigated widely owing to its high rates of convective heat transfer near the stagnation zone.Nanofluids, beyond the traditional working fluids, have great advantages in hi

会议

Al2O3-water nanofluidsingle impinging jetdimpleflow structuresheat transfer

Conjugated heat transfer analysis of a film cooling passage with and without turbulator ribs

In this study, the adiabatic film cooling effectiveness and conjugate heat transfer characteristics for a circular hole were investigated numerically.Seven turbulator ribs were located on the internal

会议

Film coolingTurbulator ribsConjugate heat transferHeat conductionMaterial

Transitional Processes and Crisis Phenomena De velopment at Boiling in Falling Liquid Film at Stepwi

The aim of this work is experimental investigation of heat transfer and crisis phenomena development at boiling in falling liquid film subcooled at the inlet or fed at the line of saturation at stepwi

会议

Falling liquid filmTransient heat transferBoiling incipienceCrisis phenomena

Heat transfer on a ribbed U-bend surface relevant for the blade-tip cooling

Tip-wall heat transfer in a U-bend channel has been examined experimentally by using the liquid crystal technique.Periodic square ribs were fitted onto the tip surface to increase the turbulence level

会议

ribblade-tip coolingheat transfer enhancementliquid crystal thermography

Heat and Mass Transfer and its Applications on LED Packaging

With advantages of high efficiency and environment protection, light emitting diodes (LEDs) have become the most popular light source in 21st century.To realize white LEDs, so far, the most popular me

会议

A Ball Super-position Model for the Radiative Characteristics of Large Nonspherical Particles

A ball super-position model combining with Monte Carlo ray tracing method used to study the radiative characteristics of large nonspherical particle was proposed.The goal of the model is to provide a

会议

RadiationNonspherical ParticleMonte Carlo MethodRay tracing

Heat transfer of H-type finned elliptical tube

How to enhance heat transfer performance and reduce tubes erosion is always a difficult task in the applications of tail flue of power plants.Three dimensional numerical simulations for flue gas side

会议

Longitudinal vortex generators (LVG)ErosionH-type fumed elliptical tubeHeat t

Application of Improved Ant Colony Optimization Algorithm to Inverse Problem of Coupled Radiation an

In this study, a continuous Ant Colony Optimization (ACO) algorithm on the basis of probability density function (PDF) was applied to the inverse problem of one-dimensional (1-D) coupled radiation and

会议

Ant Colony OptimizationCoupled radiation and conduction heat transferInverse p

Studies on characteristics of high temperature multilayer thermal insulations for hypersonic vehicle

Hypersonic vehicles have to withstand extremely high aerodynamic heating and pressure loads during the ascent and reentry stages.Multilayer thermal insulations have been widely designed in thermal pro

会议

Multilayer thermal insulationsLayer numberAerodynamic heatingLayout

Temperature fluctuation characteristics for pool boiling within space-confined structures

In this paper, the surface temperature fluctuation magnitude and frequency at the nucleation sites during boiling process within a specially designed space-confined structure is investigated using Inf

会议

Pool boilingSpace-confined structureTemperature fluctuationHeat transfer enha