【摘 要】
：
The polymer-ceramic composites of epoxy resin (EP) and barium titanate (BT) were prepared.BT powders of different BT particle sizes from 100 nm to 1 μm were us
【机 构】
：
Advanced Electronic Materials Institute
论文部分内容阅读
The polymer-ceramic composites of epoxy resin (EP) and barium titanate (BT) were prepared.BT powders of different BT particle sizes from 100 nm to 1 μm were used in the preparation.The dielectric properties, such as dielectric constant, dielectric loss and electrical breakdown strength, of the EP/BT composites were studied.The morphology of the composites was characterized by the means of scanning electron microscopy (SEM).The results show that the dielectric constant of the composites is much higher than the epoxy matrix at frequency range from 1 kHz to 10 MHz, and it is also obviously dependent on the size of BT particles.The electrical breakdown strength of the composites decreases with the increase of the BT content.The dependence of electrical breakdown strength on BT particle sizes was also discussed.
其他文献
Statistical model of magnetization reversal was used to simulate the magnetization reversal behavior in the sintered Nd-Fe-B magnets with double grain-size dist
A nozzle clogging online forecasting model based on hydrodynamics engineering was developed, in which the actual flow rate was calculated from the mold width, t
Fe100-xPtx(x=30at.%-60at.% ) nanocomposite films were deposited on natural-oxidized Si(100) substrates by magnetron sputtering. The as-deposited films were anne
CoPt nanoparticles were prepared by simultaneous thermally reducing Co(CH3COO)2 and Pt(acac)2 in oleylamine with a small quantity of oleic acid. The composition
Er doped ZnO thin films were grown on Si substrates using SiO2 buffer layer by pulsed laser deposition (PLD) method.The obtained films crystallize well and show
The microstructure and characteristics of pre-sintered strontium ferrite powderwere investigated by X-ray diffraction, scanning electron microscopy and transmis
Cu-Zn, Cu-Zn-Sn, Cu-Zn-Ni alloys were melted by vacuum smelter. The effect factors to the surface free energy of the alloys such as chemical composition, crysta
An electromagnetic anti-fouling technology(EAFT) was developed further. The operating principle of the EAFT was presented using fundamental physics laws. To val
Based on the moving least-square (MLS) approximation, the complex variable moving least-square approximation (CVMLS) is discussed in this paper. The complex var
The equation of stress intensity factors(SIF) of internally pressurized thickwalled cylinder was used as the reference case. SIF equation of rotating thick-wall