【摘 要】
：
The sapphire (Al2O3) single crystal is a kind of excellent infrared transmission window materials. A large-sized sapphire (Φ225 mm×205 mm, 27.5 kg) was grown
【机 构】
：
Center for Composite Structure
论文部分内容阅读
The sapphire (Al2O3) single crystal is a kind of excellent infrared transmission window materials. A large-sized sapphire (Φ225 mm×205 mm, 27.5 kg) was grown by SAPMAC method (sapphire growth technique with micro-pulling and shoulder-expanding at cooled center). Several kinds of inclusion in the large sapphire crystal were investigated by means of an optical microscopy (OM), scanning electron microscopy (SEM) and electron probe microanalysis (EPMA). The experimental results show that most inclusions are consisted of solid metallic and non-metallic particles as well as gas pores caused by the impurity of alumina as the raw material, the thermal dissociation of aluminum oxide melt and the reaction of the melt to the crucible material (Mo) at high temperatures. It is also found that in different crystal regions the inclusions are of varied sizes, morphology and chemical compositions. Finally, the measures to reduce and eliminate the inclusions are proposed to improve the crystal quality.
其他文献
The thermal fatigue behavior of Ni3Al based superalloy IC6E during the cycles between 900 ℃/1 000 ℃ and the room temperature was investigated. The experimenta
Based on the principle that the thermal expansion coefficient of the support structure should match that of the mirror, three schemes of primary mirror assembly
The feasibility was demonstrated to fabricate h-BN-SiC ceramics through combustion synthesis of the mixture of boron carbide and silicon powders under 100 MPa n
The microstructures, the phase transformation characteristics, and the mechanical properties of the Ti50Ni47Fe3 alloy in as-forged and as-cross-rolled states we
BaO-La2O3-B2O3 (BLB) glass, suitable to be used as a sealing between metals, was chosen to be the binder in preparing glass coats on the Ti-alloy substrate. The
首先利用高速风洞对一种与机身保形的双S进气道原始模型进行了研究,结果表明进气道出口截面总压周向畸变指数较大.继而,在低速风洞试验的基础上选择了一种基于涡流发生器的流
A heuristic iterative learning control (ILC) method is presented and applied to the trajectory tracking control of a giant magnetostrictive material (GMM) actua
It is well known that grinding techniques are main methods to machine hard and brittle materials such as engineering ceramics. But the conventional grinding has
Hexagonal-plate BaFe12O19 nano-particles were prepared by combining the co-precipitation and molten-salt method. The effects of molten-salt NaCl on the products