论文部分内容阅读
利用在束γ谱学实验技术,通过173Yb(19F,4nγ)反应布居了188Au的高自旋态,并对其准粒子带结构进行了研究.基于实验测量结果,对原有的双奇核188Au能级纲图做了较大的修改.通过系统性比较,对15+以上的能级结构进行了讨论.
双奇核188Au的准粒子带结构研究
【摘 要】
：
利用在束γ谱学实验技术,通过173Yb(19F,4nγ)反应布居了188Au的高自旋态,并对其准粒子带结构进行了研究.基于实验测量结果,对原有的双奇核188Au能级纲图做了较大的修改.通过
【机 构】
：
中国科学院近代物理研究所,中国科学院研究生院,Japan Atomic Energy Research Institute,Department of Physics,Chiba Institute
【出 处】
：
高能物理与核物理
【发表日期】
：
2004年期
其他文献
Research on the preparation of amorphous diamond nanorod arrays and their excellent field emitting p
Amorphous diamond nanorod arrays with excellent field emitting have been fabricated firstly on the AAO template by the filtered cathodic arc plasma technique. M
Ionic liquids are a distinct sub-set of liquids, comprising only of cations and anions, often with neg-ligible vapor pressure. As a result of the low or non-vol
With the TEM and physical gas adsorption techniques, porous properties of nano-fibriform silica (MLD: 92.73 %) from natural chrysotile are studied in this paper
本文通过对荣华二采区10
Structure and tribological properties of Ti-containing amorphous carbon coatings prepared by cathode
Ti-containing amorphous carbon (Ti-aC) coatings were deposited on cemented carbide and Si substrates by cathode-arc-enhanced closed field middle-frequency unbal
Thermoluminescence dating of the ancient Chinese porcelain using a regression method of saturation e
This paper studies the thermoluminescence (TL) dating of the ancient porcelain using a regression method of saturation exponential in the pre-dose technique. Th
Experimental study to confirm the existence of hydrocarbon under high pressure and temperature of de
Pyrolysis of lignite was conducted at high temperatures from 400 to 700℃ and high pressures of 1 and 3 GPa in a closed system in order to investigate pressure
Three-dimensional holographic vector of atomic interaction field for quantitative structure-retentio
A newly developed descriptor, threedimensional holographic vector of atomic interaction field (3D-HoVAIF), was used to describe the chemical structures of purin
Parametric design of typical parts holds a very important position during process of product designs. In order to develop a parametric design system of typical
Electrowetting-on-dielectric (EWOD) is to directly control the wettability of liquids on the solid surface by applying the electric potential to the microelectr