微型色谱在天然气常规组分和硫化物快速分析中的应用

来源 :天然气化工:C1化学与化工 | 被引量 : 0次 | 上传用户:h459403474
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
采用带微型热导检测器的创新型气相色谱仪,选用不同的分析模块组合对模拟天然气中的组分进行快速分析。分析结果表明,在恒定温度条件下色谱可在85 s内完成天然气中常规组分的分析,分析重复性在1%以内;120 s内完成12组分硫化物气体组分的分析,检出限为0.5~2.0μmol/mol;H2S、COS、CH3SH、C2H5SH四种硫化物在5~60μmol/mol的浓度范围内线性相关性好(R2>0.9
其他文献
Light olefins (C2-C4 olefins) are the most important basic carbon-based building blocks, which are mainly produced from the catalytic cracking of naphtha [1-3].
Zinc-ion batteries (ZIBs) are promising alternative energy storage devices to lithium-ion batteries owing to the merits of large abundance,high theoretical capa
Molybdenum phosphide(MoP),owing to its abundant reserve and high theoretical capacity,is regarded as a promising anode material for potassium-ion batteries.Howe
Aqueous rechargeable zinc-ion batteries(ZIBs)have recently attracted increasing research interest due to their unparalleled safety,fantastic cost competitivenes
A great deal of attention has been paid on developing plant-derived hard carbon(HC)materials as anodes for sodium-ion batteries(SIBs).So far,the regulation of H
Exploring electrode materials with a high volumetric energy density and high rate capability remains of a great challenge for nanosized-Li4Ti5O12(LTO)batteries.
Iron-based electrodes have attracted great attention for sodium storage because of the distinct cost effec-tiveness.However,exploring suitable iron-based electr
为解决焦炉煤气制LNG、甲醇等项目中预加氢、一级加氢、二级加氢样品中硫化物检测组分浓度差异大使得部分硫化物需要稀释进样的问题,采用价格低、普及性高的火焰光度检测器及填充柱气相色谱仪,通过减小定量环、改造信号放大组件、分段拟合等手段将直接进样检测焦炉煤气中形态硫的质量浓度检测范围拓宽至2.86~142.86 mg/m3。结果表明,在上述范围内一定浓度梯度进行复测,所得数据线性相关性高,满足相关标准要求。同时,该方法还能避免因焦炉煤气中各形态硫组分浓度差异大所造成的稀释后部分硫化物浓度过
Porous carbons were obtained from rice husk using two different chemical activation methods and they were investigated as supercapacitors.Their properties were studied using X-ray photoelectron spectroscopy,thermal analysis,potentiometric titration,and ni
Electrochemical nitrogen reduction reaction(NRR)is one of the most promising alternatives to the tradi-tional Haber-Bosch process.Designing efficient electrocat