基于微弱静电放电信号探测飞行目标

来源 :系统工程与电子技术 | 被引量 : 0次 | 上传用户:pwf890617
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
随着军事技术的发展,对隐身飞机的探测需求日益增加。依据飞行目标在飞行过程中难以避免的放电现象,设计一套利用微弱静电放电信号探测飞行目标的技术。实验证实飞行器上安装的静电放电器可将剧烈的电晕放电转变成柔和稳定的“雨淋脉冲”放电,放电辐射的峰值功率下降约40dB。进一步采用匹配滤波二值法提高系统探测能力,根据实验和仿真计算,对-30~-10dBW的微弱放电辐射信号探测距离可达5.06~50.6km。 With the development of military technology, there is an increasing demand for the detection of stealth aircraft. Based on the unavoidable discharge phenomenon of the flight target in flight, a technique of detecting the flight target by using the weak electrostatic discharge signal is designed. Experiments confirmed that the electrostatic discharge device installed on the aircraft can convert a violent corona discharge into a gentle and stable “rain shower” discharge, and the peak power of discharge radiation is reduced by about 40 dB. The matched filtering binary method is further used to improve the detection ability of the system. According to the experiment and simulation calculation, the detection range of the weak discharge radiation signal of -30 ~ -10dBW can reach 5.06 ~ 50.6km.
其他文献
1概述我公司采用CLF170×100型辊压机配VX8820型选粉机进行预粉磨,并与Ф4.2m×14.5m水泥磨组成开路联合粉磨系统。调配站原材料首先被提升至VX8820型选粉机顶部进人选
乍得700t/d熟料烧重油生产线由于一些设计方案缺陷和不合理,在试生产调试过程中,出现了C1筒飞灰量过大(20%),C3筒塌料和堵塞下料管,分解率过低(56%),分解炉塌料和漏油,产量过
0前言 在水泥企业的生产过程质量控制及产品质量的检测中,仪器分析现已逐渐取代以往的化学分析等。如荧光分析仪快速准确的优势已为广大用户所接受,并逐渐依赖仪器分析指导生
我公司水泥粉磨系统在运行过程中曾发生主机设备偶尔跳停故障。主机跳停原因很多,查找困难,但由主机自身跳停原因少,基本是保护联锁跳停引起。这里介绍我公司磨机主电机及辊
我公司生料制备采用的是ATOX50立磨。该磨自投产以来,无论是台时产量还是实际运转情况都不尽如人意。特别是2013年3月磨机因入磨回转卸料器卡滞、振停等非正常停机高达55次,平