Size distribution and source of heavy metals in particulate matter on the lead and zinc smelting aff

来源 :环境科学学报(英文版) | 被引量 : 0次 | 上传用户:dongjun1964
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
In order to understand the size distribution and the main kind ofheavy.metals in particulate matter on the lead and zinc smelting affected area,particulate matter (PM) and the source samples were collected in Zhuzhou,Hunan Province from December 2011 to January 2012 and the results were discussed and interpreted.Atmospheric particles were collected with different sizes by a cascade impactor.The concentrations of heavy metals in atmospheric particles of different sizes,collected from the air and from factories,were measured using an inductively coupled plasma mass spectrometry (ICP-MS).The results indicated that the average concentration of PM,chromium (Cr),arsenic (As),cadmium (Cd) and lead (Pb) in.PM was 177.3 ± 33.2 μg/m3,37.3 ± 8.8 ng/m3,17.3 ± 8.1 ng/m3,4.8 ± 31 ng/m3 and 141.6 ± 49.1 ng/m3,respectively.The size distribution of PM displayed a bimodal distribution;the maximum PM size distribution was at 1.1-2.1 μm,followed by 9-10 μm.The size distribution of As,Cd and Pb in PM was similar to the distribution of the PM mass,with peaks observed at the range of 1.1-2.1 μm and 9-10 μm ranges while for Cr,only a single-mode at 4.7-5.8 μm was observed.PM (64.7%),As (72.5%),Cd (72.2%) and Pb (75.8%) were associated with the fine mode below 2.1 μm,respectively,while Cr (46.6%) was associated with the coarse mode.The size distribution characteristics,enrichment factor,correlation coefficient values,source information and the analysis of source samples showed that As,Cd and Pb in PM were the typical heavy metal in lead and zinc smelting affected areas,which originated mainly from lead and zinc smelting sources.
其他文献
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生、测量监控等方面人手,介绍了S226海滨大桥
期刊
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生、测量监控等方面人手,介绍了S226海滨大桥
期刊
钢铁行业是二氧化碳及其他污染物排放的重点行业之一。太原钢铁(集团)公司作为山西省最大的工业企业,以科学发展观为统领,着力转变发展方式,把发展循环经济作为企业绿色转型的内在
短肢剪力墙结构是适应建筑要求而形成的特殊的剪力墙结构.在短肢剪力墙结构设计中,建筑平面外边缘及角点的墙肢、底部外围的小墙肢、连梁等是短肢剪力墙结构的薄弱环节.对这
介绍了低汞触媒在方大锦化化工科技股份有限公司氯乙烯装置的使用过程,以及相关的控制措施和注意事项.
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生、测量监控等方面人手,介绍了S226海滨大桥
期刊
本文根据当前饭店厨房通风设计不科学,运行后会出现各种问题.本文通过结合饭店实际的通风设计,总结经验教训,提出在饭店设计通风时,需要科学地划分系统,明确合理的厨房通风方