烧成条件对长余辉蓄光玻璃光学性能的影响

来源 :无机材料学报 | 被引量 : 0次 | 上传用户:xia226
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
以SrAl2O4:Eu,Dy长余辉发光粉体和低熔点硼硅酸盐玻璃为原料,在一定条件下合成了长余辉蓄光玻璃.研究结果表明,烧成温度和保温时间对该玻璃的发光效果影响较大.温度越高,保温时间越长,由于空气的氧化作用,蓄光玻璃的发光效果越差.本试验控制烧成温度在750~800℃间,保温时间在10min以内,能合成性能较好的蓄光玻璃.余辉衰减曲线表明蓄光玻璃的发光性能较之原始发光粉体有所下降.SEM分析表明,低温合成的蓄光玻璃中,所含能继续保持发光性质的粉体料,明显比高温合成样要多.“,”SrAl2O4:Eu,Dy long afterglow luminescence powders and low melting point B-Si glass were employed as the sources, and synthesized the long afterglow luminescence glass at suitable conditions. The results of experiments indicate that sintering temperature and soaking time have great influence on the properties of the glass, and the luminescence effect will decrease as sintering temperature and soaking time increase. In this experiment, sintering temperatures were chosen at 750~800℃ and soaking time was maintained about 10min. Under those conditions, a serious of luminescence glass with good properties was prepared. The decay curves indicate that the luminescent properties of the luminescence glass decrease compared with its original phosphor powders. The analytical results of SEM indicate that the glass prepared at low temperature containes more luminescent powders for long afterglow than that of prepared at relatively high temperature.
其他文献
期刊
期刊
期刊
期刊
期刊
期刊
期刊
1 基本情况槟城供水工程,位于马来西亚第二大城市槟城的西北边缘,座落于TELUKBAHANG河上,主体工程为土坝,设计坝高50m,设计库容2000万m3.模袋护坡工程位于土坝右岸,土坝右岸
期刊