论文部分内容阅读
J1200×3剪板机是我厂唯一的一台剪板设备。1984年因操作人员不慎,将左刀架连杆吊耳损坏断裂。由于这种设备是六十年代产品,市场已再买不到零配件,故将造成整台剪板机报废。为了挽回损失,另制作了一块连杆吊耳配件,采用粘接工艺技术,用槽套销的方法粘接,仅用两天时间就恢复了剪板机的正常运转。使用六年来,粘接处无发生脱落、松动现象。粘接工艺如下: 1、粘接结构:槽套销结构(见结构图), 2、将待接面用香蕉水清洗油污,继用丙酮清洗干净,晾干备用。 3、调胶粘接:采用江山机械厂生产的无机胶粘剂,按4∶1配制成胶。在待粘接面上均匀涂胶后,立
J1200 × 3 shears is the only one of our plant shears equipment. In 1984 due to operator inadvertently, the left turret connecting rod lug damage fracture. Because this equipment is the sixties products, the market can not buy spare parts, it will cause the entire scrapper shears. In order to restore the loss, the other produced a link lugs accessories, the use of bonding technology, with the method of grooved sleeve pin bonding, only two days to restore the normal operation of the shears. After six years of use, there is no sticking off, loose phenomenon. Bonding process is as follows: 1, the bonding structure: Groove sleeve pin structure (see the structure), 2, the surface to be banana oil to be cleaned with oil, followed by acetone to clean, dry spare. 3, glue adhesive: Jiangshan Machinery Factory production of inorganic adhesives, formulated by the 4: 1 plastic. In the adhesive surface to be evenly coated, stand