晶化温度对SAPO-34结构稳定性的影响

来源 :化学学报 | 被引量 : 0次 | 上传用户:liu0686
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
用二乙胺结构导向剂,分别在473和573K水热晶化得到两种SAPO-34分子筛材料.SEM和XRD结果表明,晶化温度升高,SAPO-34晶粒增大,结晶度提高,比表面积和孔径增大.升高晶化温度,提高了样品的最高焙烧和水蒸汽热处理承受温度.
其他文献
1,10-Phenanthrolinium N-ylides, can react with malonitrile and aromatic aldehydes via a domino-Knoevenagel cyclization to afford a new class of mhydropyrrolo[l,
Regulated and unregulated emissions from four passenger cars fueled with methanol/gasoline blends at different mixing ratios (M15,M20,M30,M50,M85 and M100) were
A series of MoTe0.15V0.1PxOn catalysts supported on the SiC were prepared by incipient wetness impregnation. The addition of P to MoTe0.15V0.1On/SiC catalysts i
Three novel conjugated polymers bearing 3,4-bis(4-hexylthiophen-2-yl)-3-cyclobutene-l,2-dione unit in their main chain have been synthesized successfully in goo
Sulfur-limestone was used in the autotrophic denitrification process to remove the nitrate and nitrite in a lab scale upflow biofilter.Synthetic water with four
Wedged and V-shaped cells have advantages on depressing strong absorption bands and keeping the photo windows wide open without absorption block. Alternatively,
用膜片与光纤尾纤端面构成非本征光纤法珀传感器,测量液体介质中局部放电产生的声波,所组成系统具有全介质结构和抗电磁干扰能力。采用尾纤分别与石英膜和微电子机械系统(micro electronic mechanical systems,MEMS)工艺获得硅膜制成传感器,根据理论分析和计算机仿真结果建立确定传感器参数的方法。应用压电超声传感器与两种膜片的光纤传感器共同测量局放产生的声发射信号。实验结果表
N-F-codoped TiO2 (NFTO) photocatalysts were synthesized by a simple sol-gel process with tetrabutyl titanate (Ti(OBu)4) as the precursor of TiO2 and ammonium fl
The micron grade multi-metal oxide bismuth silicate (Bi12SiO20,BSO) was prepared by the chemical solution decomposition technique.Photocatalytic degradation of