【摘 要】
：
Abstract:To enhance the system damping,a permanent magnet set which served as an eddy current damper was added to the magnetic levitation positioning stage whic
【机 构】
：
School of Mechanical Engineering,School of Quality and Technical Supervision
论文部分内容阅读
Abstract:To enhance the system damping,a permanent magnet set which served as an eddy current damper was added to the magnetic levitation positioning stage which consists of a moving table,four Halbach permanent magnetic arrays,four stators and displacement sensors.The dynamics model of this stage was a complex nonlinear,strong coupling system which made the control strategy to be a focus research.The nonlinear controller of the system was proposed based on the theory of differential geometry.Both simulation and experimental results show that either the decoupling control of the movement can be realized in horizontal and vertical directions,and the control performance was improved by the damper,verifying the validity and efficiency of this method.
其他文献
目的:对抗生素联合糖皮质激素用于治疗3～4级慢性阻塞性肺病的临床效果进行分析和探讨.方法:选取2014年9月至2015年9月我院收治的68例老年慢性阻塞性肺病患者作为研究对象,随机
目的:探讨长期应用抗青光眼药物对患者眼表结构的影响.方法:收集局部应用抗青光眼药物3个月以上的患者(35例49眼)和健康志愿者作为正常对照组(45例45眼),药物治疗组分为A亚组
目的:探讨四联疗法治疗幽门螺杆菌(Hp)阳性胃溃疡的临床疗效与Hp清除率.方法:选取我院在2013年3月至2015年3月间收治的90例Hp阳性胃溃疡患者的临床资料,将患者随机分为两组,
目的:探讨毛花苷C在心力衰竭伴快速型心律失常治疗中的临床效果及护理干预.方法:选取2014年9月至2015年9月在我院就医的60例心力衰竭伴快速型心律失常患者,将患者随机分为对
To further understand the dynamic deformation and impact resistance of thin-plate hull structure under impulse wave,the deformation of multi-layer steel plates
The current AASHTO load and resistance factor design (LRFD) guidelines are formulated based on bridge reliability,which interprets traditional design safety fac
With extensively using of centrifugal pumps,noise generation in these pumps is increasingly receiving research attention in recent years.The noise sources in ce
The previous research of precision grinding optical glasses with electrolytic in process dressing (ELID) technology mainly concentrated on the action of ELID an
On the basis of a multi-length scale modeling,a mixture-averaged multi-component/multiphase microsegregation model was proposed without pre-set function for the
Mg-Zn-Y-based quasi-crystal (QC) alloys were fabricated by pouring melts into different cooling media.The effects of different cooling rates on the QC morpholog