Effect of Aging on Fracture Toughness and Stress Corrosion Cracking Resistance of Forged 7475 Alumin

来源 :武汉理工大学学报(材料科学版)(英文版) | 被引量 : 0次 | 上传用户:chenman
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
The effects of two-stage aging and retrogression and reaging heat treatment on the fracture toughness and stress corrosion cracking resistance of 7475 alloy were studied. The fracture toughness, conductivity and strength of samples of nine groups under duplex aging conditions and three retrogression and reaging heat treatments were also measured. Incorporating the microstructure and property, we found that when the condition of the first order aging kept identical, the fracture toughness and stress corrosion cracking resistance increase with aging time and the second aging temperature. The optimal treatment conditions are (115℃×7h+185℃×13h) among all tested two-stage aging treatments.Although the 7475 alloy treated by RRA method shows the highest strength and its stress corrosion cracking resistance after twenty minutes retrogression can also reach the same level as those by the optimal treatment of (115℃×7h+185℃×13h),the fracture toughness is even low.
其他文献
Nanosized nickel oxide powders were prepared by thermal decomposition of the nickel citrate gel precursors. The thermal decomposition and powder materials deriv
Spherical Li(Ni1/3Mn1/3Co1/3)O2 was prepared via the homogenous precursors produced by solution spray-drying method. The precursors were sintered at different t
New layered perovskite compounds, AgxNa2-xLa2Ti3O10 (x=0.2, 0.3 and 0.5) were synthesized by an ion-exchange reaction of Na2La2Ti3O10 with AgNO3 solution and ch
Four types of steel sheets containing 0.04%, 0.09%, 0.14% and 0.36% Si, respectively, were electrodeposited with a nickel layer of 3 μm in thickness and then g
Stable binary single source precursors (SSP) for the deposition of thin films of ceramic semiconductors of composition SnO·GeO were synthesized by close circui
The amorphous Fe78Si9B13 ribbons were bend stress relaxed at various temperature well below the crystallization temperature (Tx) for different time. The effect
Using spark plasma sintering(SPS) technique, TiC particle reinforced γ-TiAl composites were prepared with varying weight fraction of TiC powders. The effects o
Spherical icosahedral quasicrystalline phase (I-phase) was obtained by introducing Ca into Mg-Zn-Y alloy under conventional casting conditions. Due to the addit
研究了非正定方差阵下,证券组合投资模型的最优投资比例系数的计算,有效边界,冗余证券的数量以及套利机会.从而为实证分析提供了理论依据和方法. This paper studies the ca
A novel carbon-sulfur nano-composite material was synthesized by heating sublimed sulfur and high surface area activated carbon (HSAAC) under certain conditions