Electrical Properties of GeTe-based Ternary Alloys

来源 :武汉理工大学学报(材料科学版)(英文版) | 被引量 : 0次 | 上传用户:wcz741335565
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Ge50-xSbxTe50 and Ge50-xBixTe50 ternary alloys were synthesized by vacuum melting at 1273 K with the starting materials of Ge, Bi, Sb, and Te. The lattice structures were analyzed based on X-ray diffraction patterns, which could all be indexed to R3m rhombic structure. Electrical properties measurements revealed that the Ge-Sb-Te ternary alloys were p-type semiconductors with high electrical conductivity of 4.5×105 S·m-1 near room temperature. And the maximum electrical property was obtained at Ge45Sb5Te50, with the power factor of 2.49×10-3 W·m-1K-2 at 640 K. Due to the existence of secondary phases, the electrical conductivity of Ge-Bi-Te system was lower and Seebeck coefficient was higher comparing with those of Ge-Sb-Te system.
其他文献
The aim of this work was to investigate the effect of waste paper fiber on the properties of cement-based mortar and the relative mechanism. The cement-based mortars with various contents and mixing way of waste paper fibers were prepared and the slump fl
By using redispersible polymer powder (RPP) and carbon fiber (CF) to adjust the flexibility and electrical properties of the smart aggregate, a new kind of smart aggregate with Z type structure was proposed. The study shows that Z type aggregate is more s
An attractive way to prepare W/TaC based cermet at a relatively low temperature was proposed and confirmed experimentally. The thermodynamics calculations indicated that the reaction between WC and Ta2O5 was feasible at as low a temperature as 1400 ℃. The
The influence of air-cooled blast furnace slag aggregates as replacement of natural aggregates on the water absorption of concrete and mortar was studied, and the mechanism was analyzed. The interface be-tween aggregate and matrix in concrete was analyzed
The stress–strain behavior and strain rate sensitivity of pre-strained Ni80Cr20 (Ni20Cr) were studied at strain rates from 4.8×10–4 s–1 to 1.1×10–1 s–1. Specimens were prepared through cold drawing with abnormal plastic deformation. The texture of the spe
We have developed a controlled-release drug carrier. Smartly controlled-release polymer nanoparticles were firstly synthesized through RAFT polymerization as the controlled-release core. The structural and particle properties of polymer nanoparticles were
Alloy powders including Ni60, WC, Cr3C2, and TiC with different mass ratios were deposited on medium carbon low alloy steel by plasma welding. Through the experiments, the optimal alloy powder rein-forcing cutter tool surface properties were discovered. T
Fluoride nanoparticles with multiform crystal structures and morphologies were successfully synthesized by a facile, effective, and environmentally friendly coprecipitation method. Transmission electron microscopy (TEM) was used to characterize the nanopa
To improve the performance of ultrasonic transducer, the samples of PZT were improved by doping. The doped PZT was observed and analyzed from the following aspects: the crystal phase structures, the surface morphologies and the dielectric constant. Accord
The electronic structure,cohesive energy and interfacial energy of ferrite(100)/NbC(100)and TiC(100)/NbC(100)interfaces have been investigated by the first-principles calculation.Moreover,the heterogeneous nuclei mechanism of NbC particle was also analyze