Ultimate capacity analysis of cladding-pumped 10/130 Tm:fiber laser

来源 :ChineseOpticsLetters | 被引量 : 0次 | 上传用户:wb2062182
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
The ultimate capacity of a cladding-pumped 10/130 Tm:fiber is experimentally investigated with a 793 nm laser diode bidirectionally pumped amplifier. The laser system works stably at the output powers of 52 W, 65 W, and 87 W. Eventually, the damage of the amplifier occurs when the output power reaches about 103.5 W with a total incident pump power of 176.8 W. Considering the incident seed power of 12.3 W, the amplifier conversion efficiency is estimated to be about 51.6% before it is damaged. With valuable exploration, we achieve the first air-cooling 60 W Tm:fiber laser at 1945.845 nm with a spectral linewidth of 0.4 nm. The laser power stability reaches 1.24% during a continuous test time of
其他文献
A single-frequency pulsed erbium-doped fiber (EDF) laser with master-oscillator power-amplifier configuration at 1 533 nm is developed. A short-cavity, erbium-doped phosphate glass fiber laser is utilized as a seeder laser with a linewidth of 5 kHz and po
Entanglement distribution between distant parties is one of the most important and challenging tasks in quantum communication. Distribution of photonic entangled states using optical fiber links is a fundamental building block toward quantum networks. Amo
期刊
A novel non-feedback precoder circuit for high-speed parallel optical differential quadrature phase shift keying (DQPSK) modulation is proposed. The alternative control signal is introduced in replacement of the conventional feedback one, which eliminates
本文提出了一种研测面内振动的技术——频闪云纹倍增技术.它可用商品化的低密度云纹栅获得高灵敏度的测量结果.
采用激光诱导TIG电弧焊方法进行了1.5 mm厚6061-T6和5083-O异种铝合金的拼焊试验,系统研究了激光的加入对焊接接头塌陷变化和力学性能的影响规律。结果表明:由于两种铝合金的化学成分和热物理性能的差异,焊接接头会出现不一致的塌陷现象;与电弧焊相比,激光的加入不仅可以有效降低焊接接头的塌陷程度,还会大幅降低焊接接头塌陷深度比的不一致程度;随着激光功率增大,焊接接头塌陷的不一致程度呈减小的趋势,导致接头受力情况发生变化,使接头强度呈先增后减的趋势。
期刊
提出了磁场辅助激光沉积类金刚石(DLC)膜技术, 在硅基底附近添加磁力线向基底收拢的磁场, 用以迫使侧向飞行的离子向基底靠拢并参与成膜。由于离子向基底的集中, 使其在膜层中含量大幅上升, 间接地减少了大颗粒的比例, 因此, 与无磁场条件下制备的DLC膜相比, 引入磁场不仅提高了DLC膜的沉积速率, 而且提高了其机械硬度; 更重要的是, 间接地证明了激光对靶材离化的高效性, 为脉冲激光沉积(PLD)结合磁过滤技术提供了可行性的依据。
A new sub-aperture overlapping area fusion algorithm based on wavelet transformation is proposed to retain high-frequency components as much as the measurements in the sub-aperture overlapping areas. The principles of sub-aperture stitching are briefly in
本文利用格林函数和图展开方法,提出了无序材料(如玻璃)中的电磁耦合场量子理论,并由此计算和分析了SiO_2和GeO_2玻璃中光的瑞利散射及各种无序对散射贡献的大小,证实了虚温度近似中关于玻璃的瑞利散射主要起源于原子密度无序涨落的假设.本文仔细地考虑了电磁耦合场量子色散对瑞利散射损耗的影响.计算表明:对SiO_2和GeO_2玻璃,在最小损耗波长,由色散引起的偏离瑞利散射λ~(-4)规律的相对误差分别为20%和11%.