二维非晶光子材料的缺陷态

来源 :光学学报 | 被引量 : 0次 | 上传用户:beautyyin123
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
应用多重散射方法计算了二维介质柱构成的非晶光子材料的缺陷态。在非晶光子材料中抽掉不同位置的圆柱会产生频率不同的缺陷模 ,但缺陷模的能量都是非常局域的 ,能量基本上集中在以缺陷波长 1/ 3为半径的圆内。这表明非晶光子材料中形成的缺陷模不仅具有周期性光子晶体的缺陷模的强局域化特征 ,同时缺陷模更富于变化 The multi-scattering method was used to calculate the defect states of amorphous photonic materials composed of two-dimensional dielectric columns. In non-photonic materials, different positions of the cylinder will be generated at different frequencies of the defect mode, but the energy of the defect mode is very localized, the energy is basically concentrated in the defect wavelength 1/3 radius of the circle. This indicates that the defect mode formed in the amorphous photonic material not only has the strong localized characteristic of the defect mode of the periodic photonic crystal, but also the defect mode is more varied
其他文献
This paper describes a parallel computing platform using the existing facilities for the digital watershed model. In this paper, distributed multi-layered struc
An overlay share mesh infrastructure is presented for high dynamic group communication systems, such as distributed interactive simulation (DIS) and distributed
隐身技术是举世瞩目的重大军事高技术之一,包括目标的外形设计和应用雷达吸波材料两个方面[1].在吸波材料中,轻质吸波材料因可显著提高军事目标的机动灵活性,而受到高度重视[
In wireless sensor networks (WSNs), a faulty sensor may produce incorrect data and transmit them to the other sensors. This would consume the limited energy and
为改善催化剂中γ-Al2O3分散层与FeCrAl基体的结合力,采用等离子喷涂技术在合金表面制备了NiCrAl/ZrO2混合涂层作为过渡层.利用X射线衍射仪、扫描电镜和电子探针仪,研究了1 0
To cope with the ever-increasing susceptibility to transient fault in modem processors, a scheme called Tri-modular Redundantly and Simultaneously Threaded proc
The poly(butylene succinate-co-terephthalate) (PBST) copolyesters with different monomer composition were synthesized by polycondensation. The isothermal crysta
报道了一台连续792 nm Ti∶Al2O3激光器纵向抽运的(Tm,Ho)∶YLF微片激光器.在室温条件下,当抽运功率为680 mW时,激光器在2.06 μm波长的输出功率达到90 mW.激光器阈值为380 m
This paper describes a data reconstruction technique for a multi-function sensor based on the Mestimator, which uses least squares and weighted least squares m
Clustering routing protocols excel in several aspects of wireless sensor networks (WSNs). This article proposes a clustering and multihop routing protocol (CMRP
期刊