【摘 要】
：
The adsorption behavior of Cd2+ on 001×7 strong-acid cation exchange resin was studied with the static adsorption method. The adsorption process was analyzed f
【机 构】
：
School of Chemical Engineering
论文部分内容阅读
The adsorption behavior of Cd2+ on 001×7 strong-acid cation exchange resin was studied with the static adsorption method. The adsorption process was analyzed from thermodynamics and kinetics aspects. The influences of experimental parameters such as pH, temperature, initial concentration and adsorption rate were investigated. The experimental results show that in the studied concentration range, 001×7 resin has a good sorption ability for Cd2+, and the equilibrium adsorption data fit to Freundlich isotherms. The adsorption is an exothermic process which runs spontaneously. Kinetic analysis shows that the adsorption rate is mainly governed by liquid film diffusion. The best adsorption condition is pH 4-5. The saturated resin can be regenerated by 3 mol/L nitric acid, and the desorption efficiency is over 98%. The maximal static saturated adsorption capacity is 355 mg/g (wet resin) at 293 K. The adsorption mechanism of Cd2+ on 001×7 resin was discussed based on IR spectra.
其他文献
7S球蛋白α’与α亚基是大豆种子贮藏蛋白的重要组分,是影响大豆营养价值与加工品质的重要因子,同时还是主要的大豆致敏原,降低它们的含量是大豆品质改良育种的最新研究热点
Recently,urban high temperature phenomenon has become a problem which results from human activities,the increase in energy consumption,and land-cover change in
利用稳态传热理论,通过已有的辽沈Ⅰ型日光温室的热阻资料建立热量平衡方程,对室内气温进行数值模拟,并与观测值进行对比分析,验证模型的可靠性.为辽沈Ⅰ型日光温室的室内温
本文针对目前公路系统基层内部审计工作存在的规范性、标准性、独立性等问题的分析,结合实践从制度、科学体系、体制、技术方法等方面提出进一步加强和改进内审工作的途径.
With rapid economy growth,building energy consumption in China has been gradually increased.The energy consumption and indoor environmental quality of 51 office
Vegetation plays a key role in improving wind environment of residential districts,and is helpful for creating a comfortable and beautiful living environment.Th
The recovery of Ni, Co and Mn from spent battery material is very important to environment protection, utilization of resources and cost reduction of the materi
A modified advanced oxidation process(AOP) utilizing a UV/electrochemically-generated peroxide system was used to fabricate titania films on chemically polished
MnOx-CeO2 composite catalysts were prepared by a coprecipitation method and tested for formaldehyde (HCHO) and carbon monoxide (CO) oxidation. X-ray photon spec
For the fulfillment of the probability-based structural design for the offshore jacket platforms in the Bohai Bay, the design factors of loads, resistance and l