论文部分内容阅读
传动轴是为了能适应输入轴和输出轴间的角度和长度不断变化的传动机构。如果安装不正确,传动轴会发生异响;传动轴震抖,严重时不能行车;中间支承轴承发响,出现早期损坏等弊端。安装时应注意以下事项:1.保证变速器第二轴与减速器主动轴的等速传动。安装传动轴滑动叉时,应使两端万向节叉位于同一平面内,如有标记的应对正。输入轴和输出轴与传动轴的夹角应相等。
The transmission shaft is a transmission mechanism that can adapt to the changing angle and length between input shaft and output shaft. If the installation is not correct, the transmission shaft will be abnormal sound; transmission shaft vibration, can not drive in serious cases; middle bearing bearing ring, there are drawbacks such as early damage. Installation should pay attention to the following matters: 1. To ensure that the second gearbox and reducer drive shaft constant speed transmission. Install the drive shaft sliding fork, the ends of the universal joint fork should be located in the same plane, if there is a mark of the response. Input shaft and output shaft angle with the drive shaft should be equal.