Analysis of Remote Sensing Images of Ground Ruptures Resulting from the Kunlun Mountain Pass Earthqu

来源 :地质学报 | 被引量 : 0次 | 上传用户:any_ray
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
On November 14, 2001, an earthquake measuring a magnitude of 8.1 occurred to the west of the Kunlun Mountain Pass which is near the border between Xinjiang and Qinghai of China. Since its epicenter is located in an area at an elevation of 4900 m where the environment is extremely adverse, field investigation to this event seems very difficult.We have performed interpretation and analysis of the satellite images of ETM, SPOT, Ikonos, and ERS-1/2SAR to reveal the spatial distribution and deformation features of surface ruptures caused by this large earthquake. Our results show that the rupture zone on the ground is 426 km long, and strikes N90-110°E with evident left-lateral thrusting. In spatial extension, it has two distinct sections. One extends from the Bukadaban peak to the Kunlun Mountain Pass, with a total length of 350 km, and trending N95-110°E. Its fracture plane is almost vertical, with clear linear rupture traces and a single structure, and the maximum left-lateral offset is 7.8 m. This section is the main rupture zone caused by the earthquake,which is a re-fracturing along an old fault. The other is the section from Kushuihuan to the Taiyang Lake. It is 26 km long,trending N90-105°E, with the maximum strike-slip displacement being 3 m, and is a newly-generated seismic rupture. In a 50 km-long section between the Taiyang Lake and the Bukadaban peak, no rupture is found on the ground. The eastern and western rupture zones may have resulted from two earthquakes. The macroscopic epicenter is situated at 65 km east of the Hoh Sai Lake. The largest coseismic horizontal offset in the macroscopic epicenter ranges from 7 m to 8 m. Based on the dislocation partition of the whole rupture zone, it is suggested that this rupture zone has experienced a process of many times of intensification and fluctuation, exhibiting a remarkable feature of segmentation.
其他文献
Objective To develop a quantitative method for methylation analysis of the p16 gene based on mismatch hybridization and chemiluminescence. Methods Genomic DNA w
利用TRS方法对双奇核164Lu的位能面进行了计算,确认了164Lu核的一条三轴超形变带,结果与实验较好地符合,同时指出了三轴超形变带的一个具体的组态.
The platinized FTO glass counter electrode was prepared by employing techniques of colloid preparation, Langmuir-Blodgett film and self-assembly. The present el
The vertical structures and their dynamical character of PM2.5 and PM10 over Beijing urban areas are revealed using the 1 min mean continuous mass concentration
The newly developed Fractional Advection-Dispersion Equation (FADE), which is FADE was extended and used in this paper for modelling adsorbing contaminant trans
Due to the large scale and complexity of civil infrastructures, structural health monitoring typically requires a substantial number of sensors, which consequen
A new method of adaptive filtering by selecting the parameter weight factor is introduced in this paper. Based on the theoretical analysis and research, this me
Resin coated sand (RCS) with phenolic resin matrix can hardly be collapsed when it is used in Al-alloy casting. Adding collapsing agent and reducing the concent
Coal Bed Methane(CBM) occurs in coal seams in the states of adsorption gas, free gas and water-dissolved gas. Its dissipating starts with desorption, and then i
A novel method was applied to the surface modification of the metal hydride (MH) electrode of the Ni/MH battery. The electrode was plated with a thin silver fil