【摘 要】
：
Nanocrystalline single-phase alloys with the nominal compositions (at%) of Nd12.3-xDyxFe79.7Zr0.8Nb0.8Cu0.4B60 (x=0, 0.5,1.5, and 2.5) were prepared by melt-sp
【机 构】
：
School of Materials Science and Engineering
论文部分内容阅读
Nanocrystalline single-phase alloys with the nominal compositions (at%) of Nd12.3-xDyxFe79.7Zr0.8Nb0.8Cu0.4B60 (x=0, 0.5,1.5, and 2.5) were prepared by melt-spinning and subsequent annealing. X-ray diffraction analysis shows that the as-spun ribbons were mainly com-posed of the amorphous phase. A slight content of Dy stabilizes the amorphous phase during annealing treatment. The grain size becomes smaller and the coercivity of the annealed ribbon is gradually improved with the increase of Dy content. Excessive Dy is harmful to the re-manence. It is found that no intergranular phase exists between the grains by high-resolution transmission electron microscopy, and the grain boundaries are crystallographically coherent in the optimally annealed sample. The optimum magnetic properties of remanence (Jr=1.09 T), coercivity (Hci=1048 kA/m), and maximum magnetic energy product ((BH)m=169.5 kJ/m3) are obtained from the x=0.5 ribbon in a post heat-treated state (700℃, 10 min).
其他文献
The effects of low temperature thermo-mechanical treatment (LTTMT) on microstructures and mechanical properties of Ti-6Al-4V (TC4) alloy were studied by optical
Twelve samples with periodic array square pillars microstructure were prepared on the silicon wafer by plasma etching techniques, on which space b of the square
This paper is concerned with the diffusive Nicholsons blowflies equation with nonlocal delay incorporated as an integral convolution over the entire past time u
Perovskite-type oxygen-permeable membrane reactors of BaCo0.7Fe0.2Nb0.1O 3 -δ (BCFNO) packed with Ru-based catalyst had high oxygen permeability and could be u
The hot-compression of Al-1Mn-1Mg (mass fraction, %) alloy sample was carried out on a Gleeble-1500 thermo-simulator at deformation temperatures from 320 to 400
CdZnTe wafers were machined by lapping and mechanical polishing processes, and their surface and subsurface damages were investigated.The surface damages are ma
住宅消费的满足程度不仅取决于自身的居住空间,还受到邻居行为、社区公共环境等影响。分析了住宅消费外部性产生的原因和影响,提出了治理住宅消费外部性的相关对策。
Satisf
The electromechanical properties of metallic single-walled carbon nanotubes (SWCNTs) in the electric field are demonstrated with a column shell model in this pa
The bulk metallic glassy (BMG) rods of [(Fe0.5Co0.5)0.72B0.192Si0.048Nb0.04]100-xYx (x=0-6) and [(FexCo1-x)0.72B0.192Si0.04]Nb0.04]96Y4 (x=0.5-0.8) were prepare
The factors involved in simulating the continuous casting process of steel and the effects of the factors on the thermal behavior were investigated. The numeric