美国加利福尼亚州建造四座利用太阳能采暖的工业厂房,它采用倾起法施工。建筑物正面是11块预制混凝土板,安装在倾斜45度的预制壁柱上,这些倾斜的预制板上设置了收集太阳能的盘形管。每块立面板的重量为50～60吨,用两部起吊能力为140吨、起重高度15米的起重机吊装就位。钢筋混凝土支撑壁柱的壁厚为61厘米,间距约11米, Four industrial buildings that use solar heating are built in California, USA, and it is constructed using a dumping method. The front of the building consists of 11 prefabricated concrete panels mounted on prefabricated sloping columns at an angle of 45 degrees. These inclined prefabricated panels are equipped with solar-powered disk-shaped tubes. The weight of each vertical panel is 50-60 tons, and two cranes with a lifting capacity of 140 tons and a lifting height of 15 meters are hoisted into place. The reinforced concrete support wall has a wall thickness of 61 cm and a spacing of about 11 meters.