针对现阶段石英加速度计零件的毛刺问题,分析了现有处理方法的缺陷。从被动去除和主动控制两条途径入手,以轭铁零件为例,在加工中引用了少无毛刺加工技术,并引进了新的去毛刺方法。强度检测结果表明,这两种方法的运用显著改善了毛刺控制的效果,值得推广和运用。 In view of the burr problem of quartz accelerometer components at this stage, the defects of the existing processing methods are analyzed. From the passive removal and active control of two ways to start with the yoke parts, for example, in the process of reference to less burr-free processing technology and the introduction of a new deburring method. Strength test results show that the use of these two methods significantly improve the effect of burr control, it is worth to promote and use.