【摘 要】
:
The fault detection problem for the nonlinear networked control system (NCS) with packet dropout and delay is investigated.A nonlinear stochastic system model i
【机 构】
:
Department of Control Science and Engineering,School of Information Science and Engineering
论文部分内容阅读
The fault detection problem for the nonlinear networked control system (NCS) with packet dropout and delay is investigated.A nonlinear stochastic system model is proposed to account for the NCS with random packet dropout and networkinduced non-uniformly distributed time-varying delay in both from sensor to controller (S/C) and from controller to actuator (C/A).Based on the obtained NCS model,employing an observer-based fault detection filter as the residual generator,the addressed fault detection problem is converted into an auxiliary nonlinear H∞ control problem.Then,with the help of Lyapunov functional approach,a sufficient condition for the desired fault detection filter is constructed in terms of certain linear matrix inequalities,which depend on not only the delay interval but also the delay interval occurrence rate and successful packet communication rate.Especially,a trade-off phenomenon between the maximum allowable delay bound and successful data packet transmission rate is found,which is typically resulted from the limited bandwidth of communication networks.The effectiveness of the proposed method is demonstrated by a simulation example.
其他文献
This paper studies a queueing model with the finite buffer of capacity K in wireless cellular networks,which has two types of arriving calls-handoff and origina
Daqu distiller's grains were co-fermented as raw materials by Trichoderma.koningii and Trichosporon cutaneum to produce microbial oils,which can provide raw mat
A new method called mixed Lagrangian and Eulerian(MiLE)method was used to simulate the continuous casting process in a mold of free-cutting steel 38MnVS.The sim
When the information of mutual coupling and shadowing effect of a conformal antenna array are unknown,the performance of direction of arrival (DOA) estimation w
The macro modeling and the solution of traffic flow with road width were investigated.Firstly,a new macro model with the consideration of road width was propose
为探究吕家坨井田地质构造格局,根据钻孔勘探资料,采用分形理论和趋势面分析方法,研究了井田7
In order to optimize the embedded system implementation for Ethemet-based computer numerical control (CNC) system,it is very necessary to establish the performa
The measured data of vibrations induced by excavation of deep-buried cavern and open pit with method of bench blasting were analyzed by Fourier Transform and Wa
A novel technique for the optimal tuning of power system stabilizer (PSS) was proposed,by integrating the modified particle swarm optimization (MPSO) with the c
To address the issue of premature convergence and slow convergence rate in three-dimensional (3D) route planning of unmanned aerial vehicle (UAV) low-altitude p