Evidence of spin density wave of CeOs4Sb12

来源 :稀有金属(英文版) | 被引量 : 0次 | 上传用户:guomingjie000111
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Elastic neutron diffraction measurements were performed on single crystals to study the ground state below the mysterious exotic transition temperature 0.86 K. An antiferromagnetic order with a tiny moment of 0.027μB per formula is formedas the ground state for CeOs4Sb12 below the transition point. Our neutron data gives the evidence of spin density wave state for CeOs4Sb12 in this work.
其他文献
The Cr3+:BeAl2O4 crystal, Cr3+:LiNbO3 crystal, and ZnO-Al2O3-SiO2 glass-ceramic were obtained by the Czochralski technique, Bridgman method, and melting process
According to the basic idea of classical yin-yang complementarity and modern dual-complementarity, in a simple and unified new way proposed by Luo, the unconven
The effect of HCO3- concentration on CO2 corrosion was investigated by polarization measurement of potentiodynamic scans and weight-loss method. Under the condi
A Fe-Ni soft magnetic film was prepared in sulphate solution by electroplating. The influences of the molar ratio of n [Fe2+ ]/ n [Ni2+ ], current density, bath
To improve the cycle performance of eco-friendly and cost-effective spinel LiMN2O4 as the Li secondary batteries, the Th-doped LiThxMn1-xO4 spinel powers were s
A standard calibration grating was used for image scanning to investigate the effect of hydration films on imaging resolution by Atomic Force Microscope (AFM).
Saturated Ca(OH)2 and AlCl3 solutions were used to synthesize calcium aluminate hydrate precipitates at room temperature; high purity calcium aluminate powders
Nanocrystalline titania films codoped with aluminum and boron were prepared by cathodic vacuum arc deposition. In the process, titanium alloy target was used un
Titanium tetrachloride (TiCl4) treatment was employed to TiO2 coating deposited on fluoride-doped tin oxide (FTO) conducting glass and indium oxide doped tin ox
Mg-xwt.%CuY (x=15, 20, 25) composites were successfully prepared by reactive mechanical alloying (RMA).X-ray diffraction (XRD) measurement shows that main phase