【摘 要】
:
Anaplastic thyroid carcinoma(ATC)is a rare but extremely lethal malignancy.However,little is known about the pathogenesis of ATC.Given its high mortality,it is critical to improve our understanding of ATC pathogenesis and to find new diagnostic biomarkers
【机 构】
:
Department of Thyroid and Breast Surgery, Tongji Hospital, Tongji Medical College, Huazhong Universi
论文部分内容阅读
Anaplastic thyroid carcinoma(ATC)is a rare but extremely lethal malignancy.However,little is known about the pathogenesis of ATC.Given its high mortality,it is critical to improve our understanding of ATC pathogenesis and to find new diagnostic biomarkers.In the present study,two gene microarray profiles(GSE53072 and GSE65144),which included 17 ATC and 17 adjacent non-tumorous tissues,were obtained.Bioinformatic analyses were then performed.Immunohistochemistry(IHC)and receiver operating characteristic(ROC)curves were then used to detect transmembrane protein 158(TMEM158)expression and to assess diagnostic sensitivity.A total of 372 differentially expressed genes(DEGs)were identified.Through protein-protein interaction(PPI)analysis,we identified a significant module with 37 upregulated genes.Most of the genes in this module were related to cell-cycle processes.After co-expression analysis,132 hub genes were selected for further study.Nine genes were identified as both DEGs and genes of interest in the weighted gene co-expression network analysis(WGCNA).IHC and ROC curves confirmed that TMEM158 was overexpressed in ATC tissue as compared with other types of thyroid cancer and normal tissue samples.We identified 8 KEGG pathways that were associated with high expression ofTMEM158,including aminoacyl-tRNA biosynthesis and DNA replication.Our results suggest that TMEM158 may be a potential oncogene and serve as a diagnostic indicator for ATC.
其他文献
Immunopathological mechanisms of schistosomiasis,a debilitating parasitic disease,are still unclear.In this study,we investigated the involvement of CX3C chemokine ligand 1(CX3CL1)and its sole receptor CX3CR1 in the development of liver fibrosis in schist
通过JmatPro软件测试了镍基粉末高温合金FGH4096平衡相图,并根据γ′相平衡态溶解温度采用OM和SEM等方法研究了不同固溶温度下的γ′相溶解结果.结果表明,热力学软件JmatPro计算的FGH4096合金中的γ′相在930~1100℃大量溶解,完全溶解温度在1100℃以上.从1110℃到1130℃晶粒尺寸从16.1μm长大至18.2μm,变化不明显,从1130℃到1160℃,晶粒迅速从18.2μm长大到28.6μm.镍基粉末高温合金FGH4096中的γ′相起到强化作用的同时,对晶粒长大具有阻碍作用
The effect of preoperative Double-J(DJ)ureteral stenting before flexible ureterorenoscopy(FURS)in the treatment for urinary stones was evaluated.We retrospectively enrolled 306 consecutive patients who underwent FURS from Jan.2014 to Dec.2017.All the pati
This study was conducted to compare the feasibility,safety and effectiveness of the combined-laparoscopic splenectomy and esophagogastric devascularization(C-LSED)with open splenectomy and esophagogastric devascularization surgery(OSED)in patients with po
系统研究了RRA处理过程回归制度对7A20铝合金组织性能的影响,测试了力学性能和电导率,利用OM和TEM(HRTEM)表征了晶界和晶内的微观组织结构.结果表明:在160℃的回归温度下,随回归时间的延长,抗拉强度由630 MPa降低到525 MPa;经120℃保温12 h的再时效处理后,抗拉强度由645 MPa升高到710 MPa;回归时间越长,再时效引起的强度增量越大,80 min时达到最大值185 MPa.在200℃的回归温度下,回归时间为10 min时,便达到峰值强度715 MPa.随回归温度提高,导
Transferrin receptor 1(TfR1),encoded by the TFRC gene,is the gatekeeper of cellular iron uptake for cells.A variety of molecular mechanisms are at work to tightly regulate TfR1 expression,and abnormal TfR1 expression has been associated with various disea
通过显微组织观察和背散射电子扫描观察了不同时间、不同温度的固溶处理对超级奥氏体不锈钢254SMO铸态组织的影响,并采用电子探针技术观察了钢中σ相的溶解过程.结果表明,随着固溶时间和温度的增加,不锈钢中的铸态枝晶组织逐渐消融,偏析逐渐消除,σ相逐渐溶解并转化为δ相(铁素体).其中1280℃ ×9 h固溶处理的效果最好.
Triptolide,a component of the Chinese herb Tripterygium wilfordii Hook F,has been proved to be effective in the treatment of rheumatoid arthritis(RA).However,its underlying mechanisms on RA have not yet been well established.We observed the inhibitory eff
对航天用紧固件TC4钛合金棒材进行固溶时效处理,对棒材不同位置进行显微组织观察、硬度和室温拉伸性能检测.结果表明:TC4钛合金棒材经固溶时效后表面至心部的组织与性能受冷却速度的影响呈现显著差异.固溶时效后的显微组织由稳定的等轴α相、弥散的马氏体α′相和亚稳定β相组成,试样端面上因冷却速度相差不大,次生α相的形态和含量没有明显差异;中部截面上边部至心部的次生α相含量逐渐增多,同时次生α相片层厚度逐渐增大并趋于等轴化.端面上不同位置显微硬度值没有明显差异,但中部截面上由边部至心部的显微硬度值呈总体降低趋势,且
利用光学显微镜、拉伸及冲击试验机等仪器研究了不同热处理工艺对5Cr钢组织和力学性能的影响,利用高温高压反应釜模拟腐蚀过程,并结合电化学测试对比分析了热轧态和调质态钢的耐腐蚀性能.结果表明:5Cr钢经淬火+回火处理后,组织中碳化物弥散析出,具有较高的强度和良好的塑、韧性.热轧态钢的腐蚀速率为0.188 mm/a,调质态钢为0.158 mm/a.调质态钢中作为阴极的碳化物(Fe3 C)少且均匀弥散分布,组织自腐蚀电位较高,腐蚀电流密度较低,电偶腐蚀程度较浅,耐腐蚀性能较好.