Effect of Nb on oxidation behavior of NiTiNb alloys

来源 :中国有色金属学会会刊(英文版) | 被引量 : 0次 | 上传用户:coffeedoly
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
The oxidation behavior of NiTi and NiTiNb alloys containing different amounts of Nb (7%, 9%, mole fraction) were studied at 800 ℃ in air. It is found that the oxidation resistance of NiTi alloy can be effectively increased by the Nb addition. Under the same oxidation condition, the mass gain of NiTi is about 7 mg/cm2, while the mass gains are only 3 mg/cm2 for Ni47Ti44Nb9 alloy and 2.4 mg/cm2 for Ni52Ti41Nb7. Moreover the oxidation resistance of single phase NiTiNb alloy is better than that of the dual-phase alloy with large amount of Nb precipitates. On the basis of thermodynamics and kinetics of oxidation, the effect of Nb alloying element on the oxidation behavior of NiTi-based alloys was discussed.
其他文献
A finite element analysis was carried out on the development of residual stresses during the cooling process from the fabrication temperature in the SiCp reinfo
Impermeability of tunnel structural material after exposure to high temperature determines residual service life and security. The present study explores imperm
Eu3+ doped SiO2 nano-crystalline glasses were prepared by sol-gel method. The broad peak of XRD pattern indicates an amorphous SiO2 matrix. The affection of ann
Long lasting phosphorescence (LLP) was observed in Eu2+, Ce3+ co-doped strontium borate glasses prepared under the reducing atmosphere due to the emission of bo
Phase formation in ternary system of complex Sc, Na and Li phosphates was studied at 950 ℃ and synthesis of new phases of definite composition was carried out.
Er3+/Yb3+-codoped oxyfluoride crystallite glass was prepared with melting technique. The compositions and the melting temperature and the annealing temperature
Based on crystal plasticity theory and surface layer model, relation of flow stress to billet dimension and grain size was built,and rationality of derived rela
The structure defects such as stray grains during unidirectional solidification can severely reduce the performance of single crystal turbine blades. A dendrite
To carry out biaxial tensile test in sheet metal, the biaxial tensile testing system was established. True stress-true strain curves of three kinds of aluminum
The (100)-orientated diamond film was deposited by hot-filament chemical vapor deposition (HFCVD) technology with a positive DC bias voltage. The morphology,X-r