D2 analysis for estimating genetic divergence in different clones of Dalbergia sissoo

来源 :Journal of Forestry Research | 被引量 : 0次 | 上传用户:liangmin888
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Genetic divergence was studied in selected 36 genotypes of Dalbergia sissoo Roxb.on the basis of seven morphological parameters.The divergence among genotypes was estimated by Mahalanobis method and genotypes were grouped into clusters by Tocher’s method.All the genotypes were classified into seven distinct clusters on the basis of seven morphological traits.Cluster 1 was the largest with 25 genotypes followed by Cluster 2(four genotypes).Cluster 3,5,6 and 7 were the divergent clusters.The D2 analysis revealed that D~2 value(39.42) between clone 5040 and clone 201 was recorded maximum.The intra-cluster distance ranged from 0.00(Cluster 3,5,6 and7) to 3.89(Cluster 1),the Cluster 3(clone 33) was the most divergent cluster with maximum inter cluster distance(13.97) with the Cluster 7.By the divergence analysis,the parents for hybridization from diverse clusters could be selected for heterotic hybrids. Genetic divergence was studied in selected 36 genotypes of Dalbergia sissoo Roxb. On the basis of seven morphological parameters. The divergence among genotypes was estimated by Mahalanobis method and genotypes were grouped into clusters by Tocher’s method. All the genotypes were classified into seven distinct clusters on the basis of seven morphological traits. Cluster 1 was the largest with 25 genotypes followed by Cluster 2 (four genotypes) .Cluster 3, 5, 6 and 7 were the divergent clusters. The D2 analysis revealed that D ~ 2 value (39.42) between clone 5040 and clone 201 were recorded maximum.The intra-cluster distance ranged from 0.00 (Cluster 3, 5, 6 and 7) to 3.89 (Cluster 1), the Cluster 3 (clone 33) was the most divergent cluster with maximum inter cluster distance (13.97) with the Cluster 7.B the divergence analysis, the parents for hybridization from diverse clusters could be selected for heterotic hybrids.
其他文献
以5~6年生蜜桃为试材,按留枝量大小不同,设4个处理,分别调查各处理总枝量、枝类比、新梢生长量、叶片质量、果实生长量.分析不同处理对总枝量和枝类组成、新梢生长量和叶片质
杨木虽在国内广泛种植,但是由于木材质疏松、早晚材差别较大,导致力学性能差,因此不能做实木地板。通过对杨木利用高压、震动的方式注入特制改性剂,以提高木材的密度、木材的
造纸机白水回收处理方式不同,所产生的效果也不同。利用厢式压滤机作为抄纸机白水回收处理系统设备,可以降低白水COD和SS含量,处理后的白水和白浆可全部回用,从而达到降低生
设计并讨论了一种高效率的基于梯形结构的扩展互作用振荡器(EIO).优化了提升器件效率的关键因素包括间隙数目、频率分隔度、间隙长度、特性阻抗R/Q和品质因数Qe,从而实现有效
在数控机床测控系统中,反馈位移和速度的检测元件通常易发生故障.本文简述检测元件工作原理,结合典型事例的维修,提出相应的维修方法及措施.
项目一、综合交通规划rn郑州航空港经济综合实验区作为国务院批准的首个以航空港经济为主体的实验区,其战略定位为:国际航空物流中心、以航空经济为引领的现代产业基地、内陆
随着无线传感器网络研究的深入,其应用愈加广泛,固定的网络结构已无法满足新增的需要,移动节点的引入扩展了无线传感器的应用领域,也带来了技术上的挑战.本文介绍了一些移动
本文针对镀膜的特殊要求,通过分析传统控制方式的不足,提出了新型的控制方式,即光纤通讯。以成都普斯特真空镀膜控制系统为例,介绍了该系统的软硬件配置,工作原理,主要控制功
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生、测量监控等方面人手,介绍了S226海滨大桥