Electrochemical characteristics and synergetic effect ofTi0.10Zr0.15V0.35Cr0.10Ni0.30-10 wt.%LaNi5 h

来源 :稀土学报(英文版) | 被引量 : 0次 | 上传用户:chenfurongyalan
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
In order to improve performance of Ti-V-based solid solution alloy,electrochemical characteristics and synergetic effect of Ti0.10Zr0.15V0.35Cr0.10Ni0.30-10 wt.%LaNi5 hydrogen storage composite electrode prepared by two-step arc-melting were investigated system-atically.X-ray diffractometry (XRD) and scanning electron microscopy-energy dispersive spectroscopy (SEM-EDS) showed that the main phase of composite alloy was composed of V-based solid solution phase with a BCC structure and C14 Laves phase with hexagonal structure,while secondary phase also existed in the composite alloy.The results showed that electrochemical characteristics of the composite alloy elec-trode were significantly improved.It was suggested that synergetic effect appeared in the maximum discharge capacity of the composite alloy,synergetic effect of the discharge capacity appeared in the activation process,in the composite process,in the cyclic process,in the discharge process at low/high temperature and at different current densities,and synergetic effect existed in the charge-transfer resistance and in the exchange current density,which seemed to be related to formation of the secondary phase.
其他文献
用水热法合成了Cu-Zn-Al-CO3双金属氢氧化物n(Cu)/n(Zn)=5,[n(Cu)+n(Zn)]/n(Al)≈2,简写为LDH),加热煅烧后得到焙烧型Cu-Zn-Al-CO3-LDH(CLDH),再采用批处理实验用其对模拟废
采用耦合流场的相场模型,模拟Ni-Cu合金过冷熔体流动对液固界面前沿浓度分布的影响;定量分析强迫层流对迎流方向、垂直流动方向与逆流方向枝晶尖端前沿浓度边界层厚度,浓度最
报道一种新奇的现象,即随着Fe75Mo5P10C8.3B1.7块体金属玻璃的直径从1.5mm增加到2.0mm,其室温压缩塑性反而从0.5%增加到1.8%.这主要归因于随着铁基块体金属玻璃样品直径的增加,
对太白山自然保护区水质状况进行了分析,并利用单项水质评价法和综合指数法对其进行了评价.结果表明:太白山自然保护区水体呈弱酸性,重金属元素含量顺序为Zn>Cu>Cr>As>Hg>Cd.保护
In this paper,based on the linear wave theory,the interaction of short-crested waves with a concentric dual cylindrical system with a partially porous outer cyl
为进一步提高Mg-A1-RE基合金的力学性能,采用高压压铸技术制备Mg-3.0Al-1.8Ce-0.3Y-0.2Mn合金,并研究其微观组织、金属间相的热稳定性和合金的力学性能.结果表明:合金由细小
采用平衡合金法,利用X射线衍射、扫描电镜及能谱分析,确定Mg-Zn-Al三元系富镁角300℃ α-Mg相平衡关系和相组成.结果表明:在富镁角存在3个三相区:α-Mg+Mg17Al12(γ)+Al5MgnZ
对离子交换膜电解槽中电沉积金属镍的条件进行优化.研究镍(Ⅱ)及硼酸浓度、pH及温度对电沉积镍的电流效率和能耗的影响.电解槽阴极液为含硼酸的硫酸镍溶液,阳极液为硫酸溶液.
通过2道次往复挤压制备细晶ZK60合金,在443~523 K和初始应变速率为3.3×10-4~3.3× 10-2 s-1的范围内测试合金的低温超塑性.结果表明:往复挤压ZK60合金的平均晶粒尺寸约为5.0
以Ti为中间层,对TiAl基金属间化合物与Ni基高温合金进行反应钎焊连接,研究反应钎焊接头的界面微观结构及剪切强度.通过实验发现,熔融中间层与两侧母材反应剧烈,生成连续的界