【摘 要】
：
Complex loading paths were realized with cruciform specimens and biaxial loading testing machine. Experimental method for determining the subsequent yield locus
【机 构】
：
School of Mechanical Engineering and Automation
论文部分内容阅读
Complex loading paths were realized with cruciform specimens and biaxial loading testing machine. Experimental method for determining the subsequent yield locus of sheet metal was established. With this method, the subsequent yield loci of 5754O aluminum alloy sheet were obtained under complex loading paths. Theoretical subsequent yield loci based on Yld2000-2d yield criterion and three kinds of hardening modes were calculated and compared with the experimental results. The results show that the theoretical subsequent yield loci based on mixed hardening mode describe the experimental subsequent yield loci well, whereas isotropic hardening mode, which is widely used in sheet metal forming fields, predicts values larger than the experimental results. Kinematic hardening mode predicts values smaller than the experimental results and its errors are the largest.
其他文献
A series of photocatalysts, K11[Ln(PW_(11)O_(39))_2]/PVA (Ln=La, Ce, Pr, Nd, Sm) were prepared by K11[Ln(PW_(11)O_(39))_2] (Ln=La, Ce, Pr,Nd, Sm) containing fiv
Orthogonal experiments are used to design the pulsed bias related parameters, including bias magnitude, duty cycle and pulse frequency, during arc ion depositio
The ratio and sensitivity of giant magnetoimpedance(GMI)in grain oriented silicon steels(Fe-4.5%Si)are improved after furnace annealing in air for 20 min.By ann
The phase and morphology transformation during the hydrothermal treating process of Y_2O_3 was evaluated with X-ray diffcrcnce (XRD), scanning electron microsco
Ti-43Al-9V-Y alloy sheets with dimensions of 300 mm×100 mm×(1.5-2) mm were produced by hot-pack rolling. After rolling, the microstructure of Ti-43Al-9V-Y all
The TiN/Ni composite coatings were deposited on 7005 aluminium alloy by high speed jet electroplating and then processed with plasma transferred arc(PTA) scanni
Plasma tungstening followed by carburization (W-C duplex treatment) was performed on the Ti2AlNb-based (O phase) alloy by using the double glow plasma process t
Ion implantation is a powerful method for fabricating nanoparticles in dielectric. For the actual application of nanoparticle composites, a careful control of n
A accelerated arithmetic algorithm of the dynamic computing regions was designed, and 3-dimensional numerical simulation of isothermal solidification for a bina
Phase transition process and magnetic entropy change -ΔS of Ni_(55.2)Mn_(18.6)Ga_(26.2-x)Gdx(x=0, 0.05, 0.15) alloys were studied.Ni_(55.2)Mn_(18.6)Ga_(26.2-x)