利用传统的四电极方法在金刚石对顶砧(DAC)上进行原住的样品电导率测量时,如果金属垫片样品孔内壁不能完全绝缘,测量结果将会存在很大的误差.为避免该实验误差的产生,作者提出了用双电极模型进行电导率测量的方法,即在DAC砧面上制备一个圆形测量电极的同时,将金属垫片样品孔的内壁做为第二个测量电极,并利用有限差分方法对电导率进行计算.通过这种方式,由金属垫片不绝缘而产生很大测量误差的问题得以解决.实验结果表明测量相对误差被控制在7%以下. When using the traditional four-electrode method to perform native sample conductivity measurements on a diamond anvil (DAC), the measurement results will be very erroneous if the inner walls of the metal gasket sample well are not completely insulated. To avoid this experiment Error, the author proposed a two-electrode model for conductivity measurement method, that is, in the DAC anvil surface to prepare a round measuring electrode at the same time, the metal gasket sample hole wall as the second measuring electrode and The finite difference method is used to calculate the conductivity, which solves the problem of large measurement error caused by the non-insulated metal gasket.The experimental results show that the relative error of measurement is controlled below 7%.