【摘 要】
:
本文分析了调整误差对GaAs激光器激发带球面透镜圆柱套层光波导纤维的影响,结果是横向偏差的影响比轴向偏差大得多,这使得基模激发效率的下降速率略快于指数函数.
论文部分内容阅读
本文分析了调整误差对GaAs激光器激发带球面透镜圆柱套层光波导纤维的影响,结果是横向偏差的影响比轴向偏差大得多,这使得基模激发效率的下降速率略快于指数函数.
其他文献
A polymer-stabilized blue phase liquid crystal display (BPLCD) with slanted wall-shaped electrodes is proposed. Compared with the traditional BPLCD with wall-shaped electrodes, the electrodes of the proposed BPLCD are slightly angled to obtain phase retar
基于瑞利近似推导了平面波入射下非均匀带电球形粒子的散射场及其散射截面,并通过数值仿真讨论了电荷非均匀分布对沙粒微分散射截面、散射效率的影响。数值结果表明:当沙粒表面电荷非均匀分布时,其微分散射截面呈明显空间分布,而电荷均匀分布时近似为各向同性散射;另外给定面电荷密度且电荷非均匀分布时带电沙粒散射效率远小于电荷均匀分布时的对应值,但在某些电荷分布角时恰好相反,随着沙粒带电量的增加其散射效率显著增加。由此说明在利用微波进行沙尘暴遥感或监测中需要同时考虑沙粒表面电荷分布规律及其携带电荷量的影响。
For enhancing the response of light-addressable potentiometric sensor (LAPS) and further improving its signal- to-noise ratio (SNR), an optical focusing method is adopted. Experimental research and theoretical analysis reveal that the magnitude of respons
The biochemical composition of atherosclerotic plaques is closely related to plaque stability and, therefore, to the associated risk of plaque evolution and rupture. Combinations of current imaging modalities, such as optical coherence tomography (OCT) wi
We address the power scaling issue in end-pumped laser rod amplifiers by studying, experimentally and numerically, the magnitude of thermal lensing in a high-energy diode-pumped Yb:YAG crystal. The spatio-temporal temperature profile of the gain medium an
Optical delay lines (ODLs) are one of the key enabling components in photonic integrated circuits and systems. They are widely used in time-division multiplexing, optical signal synchronization and buffering, microwave signal processing, beam forming and
本文根据二个椭圆偏振光场进行的理论分析,着重讨论了两个相互正交的圆偏振光(左旋和右旋〕场和一个椭圆偏振光与线偏振光场的特点,以此为基础讨论了干涉条纹移动的偏振法。
In this paper numeric analysis is made to the influence of the longitudinal mismachining tolerance (LMT) and the transverse mismachining tolerance (TMT) of the grating in the optical pick-up head (GOPH) of VCD, DVD, and CD-ROM on the transmissivity and th
固体激光器的最大输出功率受到光学元件抗辐射强度的限制。目前,直径为45毫米的钕玻璃样品,在脉冲持续时间为~30毫微秒时,最大输出为~300焦耳(玻璃不发生破坏)。进一步增大激活元件的直径则往往降低转换效率,因此也不够理想。为此,人们对直径为45毫米的多路单脉冲激光器很感兴趣。这种由主振荡器、前置放大器、将辐射分到各路放大的光学系统和放大器组成的能量体系是有益的。下面把这种系统的元件详细地介绍一下。