【摘 要】
：
Partial surge is a type of instability inception in transonic compressors and occurs in the form of axisymmetric low-frequency disturbances localized in the hub region.Previous studies illus-trate that the frequency of partial surge is set by the Helmholt
【机 构】
：
Reserach Institute of Aero-Engine,Beihang University,Beijing 100083,China;Reserach Institute of Aero
论文部分内容阅读
Partial surge is a type of instability inception in transonic compressors and occurs in the form of axisymmetric low-frequency disturbances localized in the hub region.Previous studies illus-trate that the frequency of partial surge is set by the Helmholtz frequency of the entire system,which motivates to propose a hypothesis that the system response performs an important role in the formation of partial surge.For further verification,a series of experiments are conducted to explore the link between the propagating of the partial surge and the system feedback in this study.In the first case,an additional test point is set on the wall of the plenum to detect the system response.Combining the flow behaviors inside the plenum with the disturbances in the rotor tip and stator hub/tip regions,the effects of the system feedback on the occurrence of the continuous disturbances and the rotating stall cells are illustrated.In the second case,a screen is mounted at the compressor outlet to prevent positive feedback from the plenum.The experimental results demon-strate that in the absence of system feedback,it is the occurrence of spike-type stall inception that leads to the flow instability instead of that of partial surge.In addition,three flow phenomena in the second case are discussed,including the occurrence of the single pulse,the unstable process during the stall evolution and the switch of instability inception.
其他文献
The performance of turbomachinery is largely affected by the nonuniform boundary conditions caused by the coupling between neighboring parts,such as the inlet distortion and hot streak.Existing works study this problem by comparing the flow fields with un
Manufactured blades are inevitably different from their design intent,which leads to a deviation of the performance from the intended value.To quantify the associated performance uncertainty,many approaches have been developed.The traditional Monte Carlo
The application of grooved surface structure is an emerging and effective means in tur-bulence flow control.However,for a realistic configuration,the global flow field described directly by simple application of massive grids makes it unfeasible to simula
Threaded fasteners naturally tend to loosen under vibration,impact,or alternating ther-mal load.Various anti-loosening methods or strategies are widely applied for preventing loosening,including a few anti-loosening designs and anti-loosening structures.I
The deviations of trajectory and attitude angle for internal store separation are evaluated by two wind tunnel test methods.One is the Freedrop Test (FDT),which is known as unsteady and time-dependent method of scaled model.The other is the Captive Trajec
Flow separation due to shock wave/boundary layer interaction is dominated in blade passage with supersonic relative incoming flow,which always accompanies aerodynamic perfor-mance penalties.A loss reduction method for smearing the passage shock foot via S
The thermal radiation of micron-sized condensed phase particles plays a dominant role during the heat transfer process in aluminized Solid Rocket Motors (SRMs).Open research mainly focuses on the radiative properties of alumina particles while the study c
Aviation and aerospace system are typical Phased-Mission Systems (PMSs) featured with varying configuration,phased load condition and cross phase failure correlation.The coupling effect of Functional Dependency (FDEP) and Physical Dependency (PDEP) has a
Tuned Mass Dampers (TMDs) are often attached to a main structure to reduce vibra-tion,and the TMDs\' positions are important to affect the structural dynamic performance.How-ever,the TMDs\' positions and the material layout of the structure act on eac
For a homogeneous,continuous,and isotropic material whose constitutive relationships meets with the Ramberg-Osgood law (R-O law),the energy in the elastoplastic indentation with a ball indenter was theoretically analyzed,and the proportional superposition