论文部分内容阅读
1.半轴安装技术要求AD320型推土机半轴安装在推土机机身后部的最终传动箱处,半轴内侧安装在推土机机身上,采用过盘配合,外侧通过滑套与行走架连接,中部套装推土机驱动轮。该半轴既承载着推土机后部的质量,又承受驱动轮行驶的驱动力。半轴与最终传动箱配合部位的尺寸为φ170_(-0.011)~(+0.014),最终传动箱与半轴配合的座孔尺寸为φ170_(-0.156)~(-0.116),轴与孔为过
1. Axle-mounted technical requirements AD320-type bulldozers mounted on the back half of the bulldozer at the rear of the final drive box, the inside of the half-shaft mounted on the bulldozer fuselage, with the plate with the outside through the sliding sleeve and the walkie-link, the central Set bulldozer drive wheel. The half-axle carries both the mass of the back of the bulldozer and the drive to drive the drive wheels. The size of the cooperating part between the semi-shaft and the final gear box is φ170 _ (- 0.011) ~ (+0.014). The size of the seat hole matched with the semi-shaft is φ170 _ (- 0.156) ~ (-0.116)