论文部分内容阅读
一、钢丝网片护角线该网片由薄铅皮压制而成,形状为等边直角形。边宽25～30毫米,成网状或空花,便于压入砂浆。角尖稍突出,成园形,总长3～4米(见图一)。该网片用于门洞口两边和门上过梁两侧作垂直与水乎护角线之用。施工时先按门洞高度和长度取好网片,然后用垂球和水平靠尺吊线、靠平安装网片。安装时应注意门洞口的尺寸、标高、位置须符合图纸,同时应注意网片与墙平行的一面须与墙的粉刷面平.因此网片安装应在墙面冲箭之后进行.网片安装合格后,用石膏或水泥砂浆将网片与墙固定。最后与墙面同时进行粉刷,其砂浆与墙面粉刷用料一样,使护角线与墙
First, the steel wire mesh corner line The mesh sheet is made of thin lead pressed, shaped as equilateral right-angled. Side width 25 ~ 30 mm, into a net or empty flowers, easy to press into the mortar. The tip of the corner is slightly prominent and is shaped like a garden. The total length is 3 to 4 meters (see Figure 1). The mesh is used for vertical and water protection corner lines on both sides of the door opening and on both sides of the lintel. During the construction, first take a good mesh length according to the height and length of the door, then use a vertical ball and a horizontal foot to suspend the wire and install the mesh flatly. When installing, attention should be paid to the size, elevation and position of the door opening to be in accordance with the drawings. At the same time, it should be noted that the side of the mesh parallel to the wall must be flush with the stucco of the wall. Therefore, the installation of the mesh should be carried out after the wall flushing. Mesh installation After the pass, the mesh and the wall are fixed with plaster or cement mortar. At the same time, the wall is painted at the same time. The mortar is the same as the material used for the wall painting to make the corner line and the wall.