【摘 要】
：
Using the flow stress curves obtained by Gleeble thermo-mechanical testing,the processing map of extruded magnesium alloy AZ31 was established to analyze the hot workability.Stress exponent and activation energy were calculated to characterize the deforma
【机 构】
：
School of Mechanical Engineering, Yangzhou University,Yangzhou 225127, China;School of Physics and O
论文部分内容阅读
Using the flow stress curves obtained by Gleeble thermo-mechanical testing,the processing map of extruded magnesium alloy AZ31 was established to analyze the hot workability.Stress exponent and activation energy were calculated to characterize the deformation mechanism.Then,the effects of hot deformation parameters on deformation mechanism,microstructure evolution and hot workability of AZ31 alloy were discussed.With increasing deformation temperature,the operation of non-basal slip systems and full development of dynamic recrystallization (DRX) contribute to effectiveimprovement in hot workability of AZ31 alloy.The influences of strain rate and strain are complex.When temperature exceeds 350 ℃,the deformation mechanism is slightly dependent of the strain rate or strain.The dominant mechanism is dislocation cross-slip,which favors DRX nucleation and grain growth and thus leads to good plasticity.At low temperature (below 350 ℃),the deformation mechanism is sensitive to strain and strain rate.Both the dominant deformation mechanism and inadequate development of DRX deteriorate the ductility of AZ31 alloy.The flow instability mainly occurs in the vicinity of 250 ℃ and 1 s-1.
其他文献
Electromagnetic field is an available online method to increase bonding strength of clad sheet manufactured by horizontal twin-roll casting (HTRC).In this paper,an electric current pulse (ECP) and a complex field (static magnetic field (SMF) together with
The improvement of mechanical properties of ZK60 processed by asymmetric reduction rolling (ARR) was investigated in this paper.The grain refinement and basal texture intensity decrease were attributed to the introduction of shear stress produced by ARR p
The influence of Cr doping on the surface characteristics of Ni metal,including the surface energy,work function,adsorption and dissociation,has been investigated by means of first-principles calculation based on density functional theory.The results reve
The different types of metal powder used for selective laser melting (SLM) process would cause distinct corrosion behavior due to the uniformity of the obtained microstructure.The SLM-produced Ti-5Cu alloy using atomized Ti-5Cu metal powder (SLMed Ti-5Cu)
The microstructures and mechanical properties,especially creep properties,of the NiCrFe-based alloys with various contents of phosphorus and iron were investigated.The results showed that the tensile yield strength decreased with increasing iron contents
The effects of low electromagnetic field (EMF) (B =2 mT) on the corrosion of pure copper in the absence and presence of multispecies marine aerobic bacteria were investigated in this work.The results showed that EMF has an inhibitory effect on copper meta
Low cycle fatigue behavior of a quenched and tempered high-strength steel (Q960E) was studied in the strain amplitude ranging from ± 0.5％ to ± 1.2％ at room temperature.As a result of fatigue loading,the dislocation structural evolution and fracture mechan
The precipitation kinetics of σ phase in commercial HR3C heat-resistant steel during aging at 650-800 ℃ was studied in the paper.Through morphology,composition and structural analyzing on the second phase in the HR3C steel,it was confirmed that the precip