Preparation and dielectric properties of compositionally graded (Ba,Sr)TiO3 thin film by sol-gel tec

来源 :中国有色金属学会会刊(英文版) | 被引量 : 0次 | 上传用户:gougou316
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Compositional graded BaxSr1-xTiO3 (x=0.6,0.7,0.8,0.9,1.0) (BST) thin films (less than 400 nm) were fabricated on Si and Pt/Ti/SiO2/Si substrates by sol-gel technique. A special heating treatment was employed to form the uniform composition gradients at 700 ℃. The microstructures of the films were studied by means of X-ray diffraction,atomic force microscope and field emission scanning electron microscopy. The results show that the films have uniform and crack-free surface morphology with perovskite structure phase. The small signal dielectric constant (εr) and dielectric loss (tanδ) are found to be 335 and 0.045 at room temperature and 200 kHz. The dielectric properties change significantly with applied dc bias,and the graded thin film show high tunability of 42.3% at an applied field of 250 kV/cm. All the results indicate that the graded BST thin films prepared by sol-gel technique have a promising candidate for microelectronic device.
其他文献
The optical properties of blue emitting BaAl2S4:Eu thin-films were studied. The emission peak is around 470 nm, whose FWHM (full width at half maximum) is 35 nm
Transparent polycrystalline yttria is a promising optical ceramics with excellent physical and chemical properties. A commercial yttria powder with a mean parti
The formation ability and thermal stability of phosphate laser protection glass doped with high Sm2O3 content were discussed. The characteristic temperatures (T
316L stainless steel samples,as a widespread used material,were irradiated with HIPIB at the beam parameters of ion energy 300 keV,current density 100,200 and 3
The existence of yttrium in Ti-23Al-25Nb alloy and its influence on the microstructure after heat treatment of Ti-23Al-25Nb alloy were investigated using therma
Dipolar relaxation and dielectric/piezoelectric resonance in a (001)-cut Pb(Zn1/3Nb2/3)0.9Ti0.1O3 (PZNT10%) single crystal before and after electric (E)-field p
Three different coatings, Cr, SiO2/Cr and HfO2/SiO2 were deposited by electron beam physical vapor deposition (EB-PVD). Relevant composition and mechanical prop
A novel Al-based composite material (Al63Cu25Fe12)p/A356 was prepared by spray co-deposition. It is revealed that the reinforcement of Al63Cu25Fe12 quasicrystal
The corrosion behavior of a CuCrNiAl alloy in HCl solutions was studied by means of metallograph, XRD, SEM/EDX and TEM methods. The results show that in low con
Current—voltage (I—V) and capacitance-voltage (C—V) characteristics of Au/p-CZT contacts with different surface treatments on cadmium zinc telluride (CZT) wa