过去加工电机轴承盖采用单刀切削,生产效率低,操作麻烦。现在采用活动排刀加工轴承盖,比单刀切削提高效率三倍多。例如加工JO2＃3轴承盖,原来每班只加工四十多个,活动排刀可加工一百三十多个。光洁度和精度均符合图纸要求。目前,活动排刀在我车间已广泛应用于轴类、端盖等加工方面。一、特点: 这套排刀结构简单,操作方便,它既克服了单刀切削时要经常转动刀架而造成效率低的缺点,而且克服由于位置限制不能使用固定排刀的困难,因为活动排刀能够装置几 The past processing motor bearing cover single-pole cutting, production efficiency is low, the operation is troublesome. Now the use of movable row bearing processing bearing cover, single-chip cutting to improve efficiency more than three times. For example, machining JO2 # 3 bearing cap, the original class only processing more than 40, the activity of the knife can be processed more than 130. Finish and precision are in line with drawing requirements. At present, the activities of row knife in my workshop has been widely used in shaft, end caps and other processing. First, the characteristics: The row of knife structure is simple, easy to operate, it not only overcomes the single-pole cutting tool to rotate often caused by the shortcomings of low efficiency, but also to overcome the limited position can not be used due to the difficulty of fixed row knife, Able to install a few